HP NetServer LPr System Information Front Panel Controls CD-ROM Drive Drive Activity LED Reset Switch Power ON/OFF Drive Error Drive Activity Power ON/OFF LED Switch Drive Error LED Power On/Off Switch Fan Failure LED Hot Swap Drive Shelf Over-temperature LED SCSI ID #0 Power ON/OFF Over-temperature...
Rear Panel Controls, Ports, and Indicators PCI slot 3 Network (PCI slot 4) PCI slot 2 Link LED PCI slot 1 Activitity LED Power Inlet 100 mbps LED Management Port Serial Mouse Port B Ultra SCSI Keyboard Serial Port A Parallel Monitor Port...
Memory The NetServer LPr's main memory is implemented with 5V SDRAM DIMMs (Dual In-Line Memory Modules). The NetServer LPr ships with at least 64 MB of main memory and supports up to 1 GB. Memory is available in the following DIMM capacities: 64, 128, and 256 MB.
Boot Device Priority By default, the HP NetServer searches for bootable devices in the order shown below. CD-ROM Drive Floppy Disk Drive Embedded SCSI Controller, starting with SCSI ID 0 PCI Slots in the order 3, 2, and 1 On each controller, the server scans for a boot device starting at device ID 0 and works up from there. The controller is always SCSI ID 7.
Page 7
Remote Control Card Refer to the Top Tools Administration Guide for Remote Control along with the upgrade kit documentation for information on the remote control card. Route cable through open spaces to PCI area. DO NOT route the cable over the top of sheet metal walls.
I/O Board Terminator Block Embedded SCSI Connector SCSI Cable Connector Processor Module NOTE Be sure that the VRM and the processor module associated with it are both in primary or secondary slots. Secondary Processor VRM Slot CPU Processor Secondary Processor Switch 350 MHz 400 MHz...
Replaceable Parts List * This part is not on an exploded view. Description Replacement Exchange Top Cover 5064-7036 I/O ("Riser") Board D6129-63000 D6129-69000 Fan pack 5064-5858 SCSI backplane D6021-63030 SCSI management board D6021-63031 Hot-swappable SCSI drive orderable as accessories Hot-swappable drive kit Hot-swap bay filler panel (not orderable) Floppy disk drive...
System Switches System Switches Default Settings CPU Frequency (MHz) Must Be OFF (7 & 8) On = Clear Password (6) On = Clear Config (5) Specifications Temperature Operating 5 to 35 C (41 to 95 F) Non-operating -40° to +65° C (-40° to +149° F) Humidity (non-condensing) Operating 20% to 80% relative humidity, non-condensing...