HP D7171A - NetServer - LPr Installation Manual page 2

Intra-cluster
(Heartbeat) LAN
Power source
System software:
Navigator version
Operating System
Service Pack
SPU
Model
Clock speed
No. of CPUs
BIOS version
CPU cache
RAM
No. of power supplies
Local storage
I/O slot
Default Boot Order
M/S Certified
Configuration
Storage
Local
Controller
Driver
Cabinets (Physical drive
location)
Disk drives
SCSI bus
SCSI Ids
Shared
HP Rack
Storage/12FC
For a SPOFless cluster, two D5013B NICs configured with AFT is
recommended.
Embedded NIC with crossover cable, or, configure as a VLAN through an
Ethernet switch. See Intra-cluster LAN
Direct from power mains, power conditioner or uninterruptible power
supply (UPS) using any power conditioner or UPS. Redundant power
distribution units (PDU's) are strongly recommended.
L.19.00 or later
Microsoft Windows NT 4.0
SP6a or later
HP NetServer LC 2000
1000 MHz
2
4.06.29 PV or later
Any size
128 MB minimum. Must be HP.
1 standard, 2 (for redundancy) required
See Local Storage below.
Added cards may be installed in any appropriate slot, keeping in mind the
server's default boot order as listed below:
IDE CD-ROM, FDD, SCSI A, SCSI B, PCI-1, PCI-2, PCI-3, PCI-4,
PCI64-5, PCI64-6
M/S Certified Configuration:
P1 - Local storage ( NetRAID-1Si)
P3 - Client LAN ( D5013B)
P5 - Shared Storage HBA (D8602A)
Booted from NetRAID-1Si
May use embedded SCSI, NetRAID-3Si or NetRAID-1Si.
For SPOFless, recommend NetRAID-xSi with drives in RAID-1 mirror, or
another fault tolerant RAID level.
For embedded SCSI, use sym_hi.sys version 4.12 or later.
For NetRAID-xSi, use mraidnt.sys version 2.24
SPU internal drive bays or HP external drive cabinet (e.g., HP Rack
Storage/12), any number.
Must be HP (hot swap or fixed)
Any HP cables that meet SCSI specifications and any SCSI bus speed.
Any
Required
2
below.