Installing The Tv On A Wall - Sony KLV-S19A10 - Lcd Wega™ Flat Panel Television Instructions Manual

English
Installing the TV
on a wall
The TV can be installed on a wall by attaching a Wall-
Mount Bracket (sold separately).
Verify your TV's model number and be sure to use the
bracket specified for your model only. Refer to the
Steps on this leaflet along with the Instructions
supplied with SU-WL11 or SU-LW1 Wall-Mount
Bracket, to properly carry out the installation.
Sufficient expertise is required in installing this
product, especially to determine the strength of
the wall for withstanding the TV's weight. Be sure
to entrust the attachment of this product to the
wall to Sony dealers or contractors and pay
adequate attention to safety during the
installation. We are not liable for any damage or
injury caused by mishandling or improper
installation.
For customers with
KLV-S19A10
Install the SU-WL11 Wall-Mount Bracket (sold
separately).
Step 1: Check the parts
Open the Wall-Mount Bracket package and check the
contents for all required parts along with the
Instructions.
Step 2: Decide the location
Decide where you want to install your TV. Turn to the
back cover of this leaflet for the display installation
dimensions and determine the location.
Refer to the Instructions for the SU-WL11.
Step 3: Attach bracket A to the
wall
Attach bracket A to the wall.
Refer to the Instructions for the SU-WL11.
Step 4: Remove the Tabletop
Stand from the TV
Before removing the Tabletop Stand, disconnect all the
cables from the TV.
Refer to the Instructions for the SU-WL11.
Remove the screws as shown
1
below, and remove the Tabletop
Stand from the TV.
To prevent damaging the surface of the LCD
display, place the TV on a soft mat.
Notes
• Lay the display face down on a stable and
level surface with the Tabletop Stand hanging
over the edge of the surface. Having the
display face and the base of the Stand on the
same level surface will create unstable
working condition and can damage the unit.
• Hold the Tabletop Stand firmly while
removing the last screw.
Soft mat
US
Hinge cover
(Continued)
1
(US)