Sony Walkman MZ-R900 Service Manual page 26

MZ-R900
[VOL+]
65. Adjust with the key (adjusted value up) or
key (adjusted value down) so that the adjusted value becomes
1C.
Remote commander LCD display
023
:Adjusted value
66. Press the key.
X
(0D75 is blinking)
[VOL+]
67. Press the key once to change the blinking portion to
0D76.
Remote commander LCD display
023
:Adjusted value
68. Press the x key.
(00 is blinking)
[VOL+]
69. Adjust with the key (adjusted value up) or
key (adjusted value down) so that the adjusted value becomes
03.
Remote commander LCD display
023
:Adjusted value
70. Press the key.
X
(0D76 is blinking)
[VOL+]
71. Press the key to change the blinking portion to 0D78.
Remote commander LCD display
023
:Adjusted value
72. Press the x key.
(00 is blinking)
[VOL+]
73. Adjust with the key (adjusted value up) or
key (adjusted value down) so that the adjusted value becomes
01.
Remote commander LCD display
023
:Adjusted value
74. Press the key.
X
(0D78 is blinking)
[VOL+]
75. Press the key once to change the blinking portion to
0D79.
Remote commander LCD display
023
:Adjusted value
76. Press the key.
x
(00 is blinking)
[VOL+]
77. Adjust with the key (adjusted value up) or
key (adjusted value down) so that the adjusted value becomes
E0.
Remote commander LCD display
023
:Adjusted value
78. Press the X key.
(0D79 is blinking)
26
[VOL--] [DISPLAY]
79. Press the
eral seconds (about 3 seconds) to exit the patch data write mode
(to return to the manual mode display in the test mode).
Remote commander LCD display
023
:Adjusted value
80. Press the
X
changes to CC)
81. The modified data writing is over, if the adjusted value changes
to DD.
Remote commander LCD display
023
:Adjusted value
82. Turn the power off.
[VOL--]
• Modified Data Writing Method (version 1.200 and later)
1. Select the manual mode of the test mode, and set item number
022 (see page 13).
Remote commander LCD display
022
2. Press the
X
(The modified data writing is over, if the adjusted value changes
to DD)
Remote commander LCD display
022
:Adjusted value
3. Turn the power off.
[VOL--]
[VOL--]
key on the remote commander for sev-
key to write the modified data. (The adjusted value
key to initialize the patch data.