Laser Safety Statement; Tv Antenna Connectors Protection - HP Media Center m1100 - Desktop PC Support Manual

AC Power Safety Warning
WARNING: Install the computer near an AC
outlet. The AC power cord is your PC's main AC
disconnecting device and must be easily
accessible at all times. For your safety, the
power cord provided with your PC has a
grounded plug. Always use the power cord with
a properly grounded wall outlet, to avoid the
risk of electrical shock.
WARNING: Your PC is provided with a voltage
select switch for use in a 115 or 230 VAC power
system. The voltage select switch has been pre-
set to the correct voltage setting for use in the
particular country/region where it was initially
sold. Changing the voltage select switch to the
incorrect position can damage your PC and void
any implied warranty.
WARNING: To reduce the possibility of an electric
shock from the telephone network, plug your
computer into the AC outlet before connecting it
to the telephone line. Also, disconnect the
telephone line before unplugging your computer
from the AC power outlet.
WARNING: Always disconnect the modem cord
from the telephone system before installing or
removing your computer cover.
WARNING: Do not operate the computer with the
cover removed.
WARNING: For your safety, always unplug the
PC from its power source and from any
telecommunications systems (such as telephone
lines), networks, or modems before performing
any service procedures. Failure to do so may
result in personal injury or equipment damage.
Hazardous voltage levels are inside the power
supply and modem of this product.
Lithium Battery Caution
WARNING: The PC uses a lithium battery, type
CR2032. There is danger of an explosion if the
battery is incorrectly replaced. Replace only with
the same, or equivalent, type recommended by
the manufacturer. Dispose of used batteries
according to the manufacturer's instructions.
24

Laser Safety Statement

Class 1 LED Product
The CD and DVD drives contain a laser system and are
classified as a "Class 1 Laser Product" under a U.S.
Department of Health and Human Services (DHHS)
Radiation Performance standard according to the Radiation
Control for Health and Safety Act of 1968.
Should the unit ever require maintenance, contact an
authorized service location.
WARNING: Use of controls, adjustments, or
performance procedures other than those
specified in the Upgrading and Servicing Guide
may result in hazardous radiation exposure. To
prevent direct exposure to laser beam, do not
try to open the enclosure of the CD or DVD
drives.
Laser Product Label
The following label or equivalent is located on the surface of
laser products:

TV Antenna Connectors Protection

External Television Antenna Grounding
If an outside antenna or cable system is connected to the
product, be sure the antenna or cable system is electrically
grounded so as to provide some protection against voltage
surges and built-up static charges. Article 810 of the
National Electrical Code, ANSI/NFPA 70, provides
information with regard to proper electrical grounding of the
mast and supporting structure, grounding of the lead-in wire
to an antenna-discharge unit, size of grounding conductors,
location of antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding electrode.
This label indicates that the
product is classified as a
CLASS 1 LASER PRODUCT. This
label appears on a laser device
installed in your product.