Configuring The Lan Controller - Asus ASMB-LE User Manual

ASMC Help Menu options ASMC Help Menu options ASMC Help Menu options ASMC Help Menu options ASMC Help Menu options
-flash -save filename
-flash -load filename
-i2c_read bus_num dev_num offset
-i2c_write bus_num dev_num offset data
-sdr -save filename
-sdr -load filename
-kcs[smic/bt/pci_smic] NetFn command data....
-tco enable[disable]
-bmc_ip ip_addr[10.10.10.20]
-bmc_mac
-pet_ip_mac ip_addr[10.10.10.20] mac_addr[010203040506] Write the PET destination IP and
-bmc_info
2.3.2 2.3.2

Configuring the LAN controller

Configuring the LAN controller
2.3.2 2.3.2 2.3.2 Configuring the LAN controller Configuring the LAN controller Configuring the LAN controller
Before you can establish connection to the ASMB-LE board, you must
configure the LAN port for server management being used by the remote
server to connect to the local/central server.
To configure the LAN port of the remote server:
1. On the prompt, type a s m c - t c o e n a b l e
screen displays the auto-detected information including the
motherboard name, vendor-device code, and the physical address
(MAC) of the remote server.
A:\>asmc -tco enable
Detect MotherBoard
Detect KCS Interface
======== ====== ======= ====== ============== ===================
PSCH-LR
Please shutdown the system (Standby power) to enable TCO mode!
A:\>
2. Shutdown the remote server, then disconnect the power plug from the
electrical socket to enable the TCO mode.
3. Restart the remote server from the support CD.
The TCO (Total Cost Ownership) interface for Intel
Gigabit LAN controllers allows you to manage the remote server system
even when its operating system is not fully functional.
2 - 6 2 - 6
2 - 6 2 - 6 2 - 6
O p t i o n s O p t i o n s O p t i o n s
O p t i o n s O p t i o n s
a s m c - t c o e n a b l e, then press <Enter>. The a s m c - t c o e n a b l e a s m c - t c o e n a b l e a s m c - t c o e n a b l e
-> (PSCH-LR)
Bus Dev Fun
01 01 00
D e s c r i p t i o n D e s c r i p t i o n D e s c r i p t i o n
D e s c r i p t i o n D e s c r i p t i o n
Save the current firmware to a file
Update the ASMB-LE firmware
2
Send the read I C command
Send the written I 2
Save the SDR data to file
Update the SDR data from file
Send IPMI command
Enable or disable TCO mode
Write the BMC IP address
Auto-write the BMC MAC addresses
MAC addresses
Displays the BMC and PET IP and MAC
addresses
Vendor-Device
8086 - 1075 00-11-2F-0F-A2-21
®
C h a p t e r 2 : I n s t a l l a t i o n C h a p t e r 2 : I n s t a l l a t i o n
C h a p t e r 2 : I n s t a l l a t i o n C h a p t e r 2 : I n s t a l l a t i o n C h a p t e r 2 : I n s t a l l a t i o n
C command
MAC
Fast Ethernet and