Table of Contents
Advertisement
1-1-1
Software Reboot
To reboot for the software setting.
1-1-2
CPU Factory Reset
This function is to set the CPU (DMC-1002) back to the default setting in
case of the messy setting.
1-1-3
Factory Reset
This function is to set both CPU (DMC-1002) and all system (all smart
device installed in chassis) back to the default setting in case of the messy
setting.
1-1-4
Image Update
The section is to set the TFTP Server IP Address first, and the default address
was set to "192.168.1.2". The Image File can be updated by uploading the
image file from the TFTP server. (Figure 3.1)
Note: The content of the image file will write the whole firmware of the
management module, please be sure that the image file is correct.
Figure (2) Configuration
7
Advertisement
Table of Contents
