Canon RE-350 Control Interface Commands Manual page 12
Video visualizer
Hide thumbs
Also See for RE-350:
- Instruction manual (23 pages) ,
- Brochure & specs (4 pages) ,
- Pin assigments manual (1 page)
Table of Contents
Advertisement
1.3.3 Procedure for Using the Control Knobs
Mode
[O
-L
] Mode
FF
INE
[O
-L
] Mode
N
INE
[N
] Mode
OTIFICATION
Note:
When the mode of the
RE-350
center target value for Auto-White Balance will be changed from the value in the Auto-White Balance control knob
position buffer to the physical position of the Auto-White Balance control knob automatically. The manual white
balance data given from the
Adjusting the value of each control knob.
The physical position of each control knob on the front panel is used to measure and
adjust it's respective value.
Setting the center target value for Auto-White Balance.
The physical position of the white balance control knob will be used as the center
value to measure and adjust the white balance.
Adjusting the value of each control knob.
The physical position of each control knob on the front panel will be disregarded
and the value of the "command data packet" from the
and adjust the control knob's respective value.
Setting the center target value for Auto-White Balance.
The control knob's physical position will be saved into the Auto-White Balance
position buffer when the
proper command data to set the Auto-White Balance control knob's position, the
buffer data will be updated.
Adjusting the value of each control knob..
The physical position of each control knob on the front panel will be disregarded
and the value of the "command data packet" from the
control's respective value.
Setting the center target value for Auto-White Balance
The control knob's physical position will be saved into the Auto-White Balance
position buffer when the
proper command data to set the Auto-White Balance control knob's position into
the buffer, the given data will be updated.
shifts from [O
-L
] Mode or [N
N
INE
will be disregarded.
PC
Meaning
shifts to [O
-L
RE-350
N
INE
shifts to [O
-L
RE-350
N
INE
] Mode to [O
OTIFICATION
will be used to measure
PC
] Mode. If the
gives the
PC
will be used to adjust the
PC
] Mode. If the
gives the
PC
-L
] Mode, the
FF
INE
12
Advertisement
Table of Contents
