Lan Main Setup Menu; 1-Setup Tcp/Ip; 1-Boot Method - Brother NC-8100h User Manual

CHAPTER TWO
21
Front Panel Setup Menu

LAN Main Setup Menu

The LAN menu selections allow you to setup the Brother FAX/MFC for your
network and Internet Fax configuration. Press [Menu] then press the appropriate
number for LAN, based on the selections displayed on your machine. After you
have displayed the LAN Main Setup menu, there are six main selections: 1-
Setup TCP/IP, 2-Setup Internet, 3-Setup Mail RX, 4-Setup Mail TX, 5-Setup
Relay and 6-Setup MISC. Proceed to the menu selection you wish to configure.
Please note that once you have specified a valid IP address for the machine, it is
also possible to configure many aspects of the FAX/MFC using your favorite
web browser. For added flexibility, the FAX/MFC is supplied with the BRAdmin
®
Professional Windows
aspects of the NC-8100h.

1-Setup TCP/IP

This menu has eight sections: 1-Boot Method, 2-IP Address, 3-Subnet Mask, 4-
Gateway, 5-Host Name, 6-WINS Config, 7-WINS Server and 8-DNS Server.

1-BOOT METHOD

1. Press the [Menu] button to display the configuration menu.
2. Select LAN.
3. Press [1] [1].
4. Press ! or " to select AUTO, STATIC, RARP, BOOTP or DHCP.
5. Press [Set] to accept the selection.
6. Press [Stop/Exit] to exit the configuration menu.
7. Now make sure that you power cycle the FAX/MFC.
CHAPTER 2 FRONT PANEL SETUP MENU
2
software, which also can be used to configure many
2-1