CHAPTER 3 INSTALLATION
3.5 Checking Images and Operations
Step
1
Press a key on the control panel (other
than the Copy Start key) to make sure
that operation is normal.
2
Set the CA-1 Test Chart on the
copyboard, and make a copy to check
the image.
3
If you have made adjustments, select
'ADJSUT > PASCAL' in service mode,
and check that 'PASCAL' is set to '1'.
Otherwise, set it to '1'.
4
Press the Reset key to end service mode.
5
If you have made adjustment, execute
"Auto Graduation Correction > full
correction" in user mode. (Paper need
to be fed from A3 or B4 cassette. If not
set, feed A3/B4 paper from multifeeder).
6
Check the external covers for damage
and deformation.
7
Clean up the area around the machine.
8
Fill out the service sheet.
3-26
Work
COPYRIGHT © 2001 CANON INC.
Remarks
• Make sure there is no abnormal noise.
• Check the copy image for each default ratio.
• Make sure that the specified number of copies
are made normally.
• Try each cassette, paper deck, and
multifeeder.
• If the image is not normal, make adjustments
according to the "Basic Image Adjustment
Procedure."
2000 2000 2000 2000
CANON CLC5000 REV.0 JAN. 2001