Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZKH 2145
Summary of Contents for Zanussi ZKH 2145
- Page 1 User manual Washer Dryer ZKH 2145...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Daily Use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 13 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Use - Drying _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 15 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5... - Page 3 • After having installed the appliance, check that it is not tumble dry items which have been washed in water or standing on the inlet and drain hose and the worktop is require airing. not pressing the electrical supply cable against the •...
-
Page 4: Product Description
Product description Detergent dispenser drawer Control panel Door opening handle Rating plate Drain pump Adjustable feet Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. -
Page 5: Control Panel
Control panel On the following page there is a picture of the control panel. It shows the programme selector dial as well as the buttons, pilot lights and the display. These are presented by relevant numbers on the following pages. Programme selector dial Extra rinse button Spin button... - Page 6 = Iron Dry = Delay Start 1-8 Programme selector dial, spin speed button, Start Pause drying level and time, and available options This button allows you to start or to interrupt the selected programme. Programme Selector Dial Delay Start It allows you to switch the appliance on/off and/or to se- lect a programme.
-
Page 7: Washing Programmes
• Delayed start • Incorrect option selection The Selected delay set by pressing the relevant button If an option which is not compatible with the set wash appears on the display for a few seconds, then the du- programme is selected, the message Err is displayed at ration of the selected programme is displayed again. - Page 8 Programme - Maximum and Minimum Temperature - Cycle De- Detergent Compart- scription - Maximum Spin Speed - Maximum Fabrics Load - Options ment Type of Laundry Synthetics SPIN 60° - 30° RINSE HOLD Main wash - Rinses SUPER QUICK Maximum spin speed at 900 rpm EXTRA RINSE Max.
- Page 9 Programme - Maximum and Minimum Temperature - Cycle De- Detergent Compart- scription - Maximum Spin Speed - Maximum Fabrics Load - Options ment Type of Laundry Sport Intensive SPIN 40° RINSE HOLD Prewash - Main wash - Rinses Maximum spin speed at 900 rpm Max.
-
Page 10: Automatic Drying Programmes
Automatic Drying programmes Degree of Drying Type of Fabric Max Load STORE DRY Cotton and linen (bathrobes, bath 3,5 kg Suitable for items to put away without ironing towels, etc) STORE DRY Synthetics and mixed fabrics Suitable for items to put away without ironing (jumpers, blouses, underwear, 2 kg household linen) -
Page 11: Drying Hints
Dried grease stains: moisten with turpentine, lay the gar- • powder detergents for all types of fabric ment on a soft surface and dab the stain with the fingertips • powder detergents for delicate fabrics (60°C max) and and a cotton cloth. woollens Rust: oxalic acid dissolved in hot water or a rust removing •... -
Page 12: First Use
ers, quilts, sleeping bags and duvets must not be ma- Garment labels chine dried. For drying, follow the indications given on the manufac- • Avoid drying dark clothes with light coloured fluffy turer’s labels: items such as towels as these can attract the fluff. •... -
Page 13: Daily Use
There are two different ways to set this option: To enable or disable this option press simultaneously for about 6 seconds buttons 2 and 3 until on the display, the Before pressing button 7: it will be impossible to icon appears or disappears. - Page 14 Select the Delay Start by pressing button 8 The washing water in the tub will be not emptied out. Before you start the programme, if you wish to delay the Interrupting a programme start, press this button to select the desired delay. Press the button 7 to interrupt a programme which is run- The selected delay time value will appear on the display ning, the corresponding pilot light starts blinking.
-
Page 15: Use - Drying
brightness of the display is reduced. By pressing any but- ton the appliance will come out of the energy saving sta- tus. Use - Drying Drying only The programme time will automatically increase by some minutes. Caution! Press button 7 to start the programme. The time re- The recommended load size is 3,5 kg for cottons and lin- maining is updated every minute. -
Page 16: Care And Cleaning
For cottons and synthetic the lowest value you can Switch the machine on by turning the selector dial to select is 900 r.p.m. the set washing programme/fabric. Set the dryness degree by pressing button 3. The Select the required options by pressing the relevant display shows the whole duration of the washing and buttons. - Page 17 Cleaning the drawer recess Pull out the emergency emptying cap from the Having removed the draw- pump cover, using pliers. er, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess.
- Page 18 Replace the filter into the pump by inserting it correctly • Screw the hose back onto the tap. Make sure the into the special guides. Screw the pump cover firmly by connection is tight. turning it clockwise. Replace the emergency emptying cap into the pump cover and fix it firm- •...
-
Page 19: What To Do If
• open the pump door; • screw the pump cover again and close the door. • place a bowl on the floor. Remove the emergency emp- Important! Every time you drain the water through the tying cap from the filter. The water should drain by emergency emptying hose you must pour 2 litres of water gravity into the bowl. - Page 20 Problem Possible cause/Solution The water tap is closed. • Open the water tap. The inlet hose is squashed or kinked. • Check the inlet hose connection. The machine does not fill: The filter in the inlet hose or the inlet valve filter are blocked. •...
- Page 21 Problem Possible cause/Solution The programme is still running. • Wait the end of washing cycle. The door lock has not been released. The door will not open: • Wait until the pilot light 9 goes off. There is water in the drum. •...
-
Page 22: Technical Data
If you are unable to identify or solve the problem, contact our service centre. Before telephoning, make a note of the model, serial number and purchase date of your machine: the Service Centre will require this information. Mod..Prod. -
Page 23: Installation
Installation Unpacking Positioning All transit bolts and packing must be removed before us- Install the machine on a flat hard floor. Make sure that air ing the appliance. circulation around the machine is not impeded by carpets, You are advised to keep all transit devices so that they can rugs etc. - Page 24 Water drainage The end of the drain hose can be positioned in three ways: Hooked over the edge of a sink using the plastic hose 35° 45° guide supplied with the machine. Open the porthole and extract the inlet hose. Connect the hose with the angled connection to the ma- chine.
-
Page 25: Electrical Connection
Electrical connection Information on the electrical connection is given on the Caution! The power supply cable must be easily rating plate on the inner edge of the appliance door. accessible after installing the machine. Check that your domestic electrical installation can take the maximum load required, also taking into account any Caution! Should the appliance power supply cable other appliances in use. - Page 28 www.zanussi.com/shop...