Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZKN 7147 J
Summary of Contents for Zanussi ZKN 7147 J
- Page 1 User manual Washer Dryer ZKN 7147 J...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Daily Use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 13 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Use - Drying _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 15 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5... - Page 3 • After having installed the appliance, check that it is not tumble dry items which have been washed in water or standing on the inlet and drain hose and the worktop is require airing. not pressing the electrical supply cable against the •...
-
Page 4: Product Description
Product description Detergent dispenser drawer Control panel Door opening handle Rating plate Drain pump Adjustable feet Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. -
Page 5: Control Panel
Control panel On the following page there is a picture of the control panel. It shows the programme selector dial as well as the buttons, pilot lights and the display. These are presented by relevant numbers on the following pages. Programme selector dial Extra rinse button Spin button... - Page 6 Available options: The display shows the following information: 10.1: Child safety lock Super Quick This device permits you to leave the appliance unattended Short cycle for lightly soiled items or for laundry which during it's functioning. needs only freshening up. We recommend you to reduce 10.2: the fabrics loading.
-
Page 7: Washing Programmes
Washing Programmes Programme - Maximum and Minimum Temperature - Cycle De- Detergent Compart- scription - Maximum Spin Speed - Maximum Fabrics Load - Options ment Type of Laundry Cottons SPIN 90° - 60° RINSE HOLD Main wash - Rinses SUPER QUICK Maximum spin speed at 1400 rpm EXTRA RINSE Max. - Page 8 Programme - Maximum and Minimum Temperature - Cycle De- Detergent Compart- scription - Maximum Spin Speed - Maximum Fabrics Load - Options ment Type of Laundry Easy iron SPIN 40° RINSE HOLD Main wash - Rinses EXTRA RINSE Maximum spin speed at 900 rpm Max.
-
Page 9: Automatic Drying Programmes
Programme - Maximum and Minimum Temperature - Cycle De- Detergent Compart- scription - Maximum Spin Speed - Maximum Fabrics Load - Options ment Type of Laundry Rinses SPIN Maximum spin speed at 1400 rpm RINSE HOLD Max. load 8 kg EXTRA RINSE With this programme it is possible to rinse and spin cotton gar- ments which have been washed by hand. -
Page 10: Helpful Hints And Tips
Timed Programmes Suggested dry- Spin Speed Degree of Drying Type of Fabric Drying Load ing time (mi- (rpm) nutes) Cupboard dry Cotton and linen (bath- 6 kg 185 - 205 Suitable for items to put away with- robes, bath towels, etc) 4 kg 1400 110 - 120... -
Page 11: Drying Hints
Red wine: soak in water and detergent, rinse and treat with If using liquid detergents, a programme without prewash acetic or citric acid, then rinse. Treat any residual marks must be selected. with bleach. Your appliance incorporates a recirculation system which Ink: depending on the type of ink, moisten the fabric first allows an optimal use of the concentrated detergent. -
Page 12: First Use
• Also, fabrics containing residue of setting lotions or • = Do not tumble dry. hair sprays, nail solvents or similar solutions must not Drying cycle duration be machine dried in order to avoid the formation of The drying time may vary depending on: harmful vapours. -
Page 13: Daily Use
Daily Use Load the laundry Turn the selector dial to position to reset the pro- gramme/to switch the machine OFF. Open the door by carefully At the end of the programme the selector dial must be pulling the door handle turned to position , to switch the machine off. - Page 14 Select the Delay Start by pressing button 8 Interrupting a programme Before you start the programme, if you wish to delay the Press the button 7 to interrupt a programme which is run- start, press this button to select the desired delay. ning, the corresponding pilot light starts blinking.
-
Page 15: Use - Drying
Use - Drying Drying only Press button 7 to start the programme. The time re- maining is updated every minute. Caution! At the end of the programme, the buzzer sounds. The The recommended load size is 4 kg for cottons and linen blinking appears on the display. -
Page 16: Care And Cleaning
Set the dryness degree by pressing button 3. The Select the required options by pressing the relevant display shows the whole duration of the washing and buttons. the set drying cycle. If possible, do not select a spin speed lower than Start the programme by pressing button 7. - Page 17 Cleaning the dispenser drawer appliance is hot. The water must be cold before you clean the drain pump. The washing powder and additive dispenser drawer should be cleaned regularly. Proceed as follows: Remove the drawer by To aid cleaning, the top Open the pump door.
- Page 18 Caution! When the appliance is in use and Pull back the drainage duct. depending on the programme selected there can be Unscrew the filter and remove it. hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty.
-
Page 19: What To Do If
Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. Emergency emptying out 35° 45° If the appliance cannot drain the water, proceed as follows to empty out the machine: pull out the plug from the power socket;... - Page 20 Problem Possible cause/Solution The door has not been closed. • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown.
- Page 21 Problem Possible cause/Solution Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose;...
- Page 22 Problem Possible cause/Solution The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rota- tion of the drum. This may happen several times before the unbalance disap- pears and normal spinning can resume.
-
Page 23: Technical Data
If you are unable to identify or solve the problem, contact our service centre. Before telephoning, make a note of the model, serial number and purchase date of your machine: Mod..the Service Centre will require this information. Prod. -
Page 24: Installation
Installation Unpacking Positioning All transit bolts and packing must be removed before us- Install the machine on a flat hard floor. Make sure that air ing the appliance. circulation around the machine is not impeded by carpets, You are advised to keep all transit devices so that they can rugs etc. - Page 25 Caution! Before connecting up the appliance to new There should be a minimum vertical distance of 5.02 m pipework or to pipework that has not been used for (16.5 ft) between the appliance’s inlet and the bottom of some time, run off a reasonable amount of water to flush the water storage tank.
-
Page 26: Special Conditions
Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. In the interest of the environment The appliance should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river. -
Page 27: Environmental Concerns
In the event of having to change the fuse in the plug sup- MUST be carried out by our Service Force Centre. The plied, a 13 amp ASTA approved (BS1363/A) fuse must be appliance should not be connected to the electrical supply used. - Page 28 www.zanussi.com/shop...