Step 3-Reassembling The Workstation - HP Xw6600 - Workstation - 2 GB RAM Installation Manual

Step 3—Reassembling the workstation
After installation, reassemble the workstation using the instructions in the workstation documentation.
The reassembly process involves reinstalling the side access panel.
Step 4—Connecting eSATA devices to the workstation
Follow the manufacturer's instructions when connecting eSATA devices to the HP eSATA adapter.
Step 5—Setting the BIOS for eSATA operation
1. Power up the workstation.
2. Press F10
corner of the screen.
NOTE:
on, and press
the opportunity to press F10.
3. Select your language from the list and press Enter.
4. Set the SATA/eSATA port speed for each port connect to the eSATA adapter, as shown in the
following steps. Omit the respective steps for an eSATA port that is not connected to the eSATA
adapter.
5. Use the arrow keys to scroll to Storage > Storage Option > SATA/eSATA Speed Port4 Setup.
6. Use the arrow keys to select: GEN1/1.5Gbps (eSATA).
7. Use the arrow keys to scroll to Storage > Storage Option > SATA/eSATA Speed Port5 Setup.
8. Use the arrow keys to select: GEN1/1.5Gbps (eSATA).
9. To apply and save changes, select File > Save Changes and Exit.
6 HP eSATA PCI cable kit installation
as soon as your display is active and you see F10=Setup appear in the lower-right
If you do not press F10
F10 again to access the utility, or press
at the appropriate time, try again. Turn the workstation off, then
Ctrl + Alt + Delete before boot if you miss
ENWW