Basic Set-Up - Hitachi PDV302 Instruction Manual

Preparing the Remote Control
1. Remove the plastic protecting sheet before use.
2. Operation angle : about + / - 30 degree in each the direction of the front of the IR sensor.
3. Plug the AC / DC adapter into a household mains power outlet.
Usage of Adapter
1. The player is supplied with an AC/DC adapter.
2. Connect the AC/DC adapter to the DC power in jack at the side of the DVD player.
3. Plug the AC/DC adapter into a household mains power outlet.
Install / Detach the Battery Pack
1. Follow the illustrations to install the battery pack.
2. Press the release button at the right side of battery pack, follow the direction to uninstall the battery pack from the
unit.
move battery
Using the Rechargeable Li-ion Battery Pack
1. Connect the AC/DC adapter lead to the unit and plug the AC adapter into a mains socket.
2. Switch off the unit by pressing and holding the STOP button for 2 seconds.
3. The battery will start to charging automatically, at this moment, the charging LED will blink.
4. When the charge LED stops blinking, charging is completed.
Notes :
1. Charge the battery pack before using it for the first time. Charge time is normally between 3~4 hours. Battery pack
should be fully charged before use.
2. Charge only with the supplied AC/DC adapter.
3. Do not charge for more than 4 hours as it could reduce service life.
4. When playing the unit in conjunction with the battery pack and the green power LED blinks, this indicates that battery
power is low and the battery should be recharged.
5. When the battery pack is being charged, the CHARGE LED will blink, when charging is completed, the LED will be
constantly illuminated.
6. When the unit is simultaneously connected to the battery pack and AC adapter, the unit will automatically select the
AC adapter as its power source.
7. Remove the battery pack to avoid leakage if you do not use your set for more than one month.
Playback Preparation / Quick Operation Guide
1. Connecting to power ( AC/DC adapter, external DC power source through Cigarette connector cable or with attached
battery pack ).
2. Lift the main cover up ( display screen ), and open the disc cover by pressing the OPEN knob.
3. Load the disc and close the door lid.
4. Press the " PLAY ' key to switch on the power.
5. Adjust the volume to your desired level.

BASIC SET-UP

AC / DC Adapter and Player
Battery Pack
Battery Pack
Main Unit
Uninstall
Battery Pack Install / Uninstall
DC IN 12V
To AC mains
power source
release the button
8
Battery Pack
move battery
Battery Pack
Main Unit
Install