Power Connection; Power On-Off; Antenna Connection - Hitachi HDR165 Instruction Manual

Power Connection

IMPORTANT: The set-top box is designed to operate on 12 V DC. For this, an adaptor is
used which gives 12 V voltage. Connect this adaptor to a system that supplies 220-240V
AC,50Hz.
• After unpacking, allow the set-top box to reach the ambient room temperature before you connect the set
to the mains

Power On-Off

Connect all cables before plugging into the mains. After plugging in the mains cord of the set-top-box to the
mains supply, a light will be seen on the front panel (Standby mode). When the set-top-box is first powered
up please wait until the box is initialized before activating the receiver since booting of software will take some
time. Make sure that all cable connections are in place. Plug the mains. Please wait until unit is initialized.
This may take almost a minute.
This product conforms the latest European Union Power Consumption Regulations and features low power
standby mode. Product enters into the low power standby mode approximately 2-3 minutes later after you
press standby button to turn off the unit. Until low power mode is activated, clock will be displayed at the
display. When the low power mode is activated, display will be shut down. When you press standby button
during low power mode, it may take a minute until product is initialised. However if you press standby button
before low power mode is activated unit will be initialized in a couple of seconds (Active standby mode).
Although it is not recommended for enviromental reasons, you may disable low power mode in your product
at setup –configuration menu.
Important Note : If there is any ongoing programme recording or if any EPG programme recordings and/or
manual recordings is set to a nearby time, the unit does not switch to low power mode and remains in active
standby mode until recording tasks have been finished. At low power mode, the unit initializes a couple of
minutes before the actual time of the incoming recording task.
Important Note : The unit initializes time to time to receive updates from EPG broadcast in order to sycnronize
EPG recording tasks properly. After getting updates, the unit switches to low power mode automatically. This
takes a short while and it is not a malfunction.

Antenna Connection

English - 7 -