Advertisement
BNC connectors :
Connect double shielded coaxial cables with BNC connector at the
monitor ends. This monitor has five (5) BNC input connectors,
however, number of cables required depends on the graphics board
sync signal output.
(1)
Sync on Green signal : Three (3) cables
H/V composite signal : Four (4) cables
(2)
H, V separate signal : Five (5) cables
(3)
If the graphics board supplies more than one type of sync signal, use
less number of cables. See "COMPATIBILITY" section for details.
(4)
Turn monitor power on first, then computer.
When display comes on adjust the screen size and location. Display
can be centered by H. (Horizontal) and V. (Vertical) position controls
on the front.
Display size may also be adjusted by H. and V. size controls. Do not
exceed 290 mm wide and 220 mm height as the monitor quality can
be reduced outside these dimensions.
Display location on the screen and the size may change when you
switch one application software to another one.
Brightness control shall be set so that the background raster is not
seen. Set Contrast control to a comfortable foreground brightness.
Adjust Tilt and Swivel to suit your eye level.
DO NOT use the monitor with a bright background light, direct
sunshine, or bright light into the screen area. These may increase
eye fatigue.
Use the Degaussing switch when you see impurity of colour in the
screen usually after turning on the monitor. This monitor will
automatically degauss after power on and this manual control NOT
usually necessary.
Pincushion distortion will occur when the H. size control is set to
maximum with certain signals. In this case, adjust the H. size
control and use it within the range where pincushion distortion
does not occur.
User Manual 9
Advertisement
