Table of Contents
Advertisement
HITACHI
COLOUR
MONITOR
CM811 ET
USER
MANUAL
..... I
CM812ET
BEDIENUNGSANLEITUNG...19
CM813ET
MANUAL
DE
USUARIO...33
CM814ET
MANUALE
D'USO...47
MANUEL
UTILISATEUR...(3I
with
Easy Men u !
EasyMenu
IS HITACHI'S On Screen Display function for easy operat[on
Oceooo
00
00 0.0
/
\
READ THE INSTRUCTIONS
INSIDE CAREFULLY.
KEEP THIS USER MANUAL FOR FUTURE REFERENCE.
For future reference, record the serial number of your colour monitor.
SERIAL
No.
The serial number is located on the rear of the monitor.
This monitor is
ENERGYSTAR@
compliant when used with a computer
Q*
equipped with VESA DPMS.
The
ENERGY STARo
emblem does not represent EPA endorsement
of any product or service.
100%
As an
ENERGYSTAR@
Partner, Hitachi,Ltd. has determined that this
~+
%0
@
~
product meets the
ENERGYSTARo
guidelines for energy efficiency.
4.
l-!
%L
&"
+.
liaa~~
Advertisement
Table of Contents
Related Manuals for Hitachi CM813ET
Summary of Contents for Hitachi CM813ET
- Page 1 CM814ET MANUEL UTILISATEUR...(3I Easy Men u ! with EasyMenu IS HITACHI’S On Screen Display function for easy operat[on 00 0.0 Oceooo READ THE INSTRUCTIONS INSIDE CAREFULLY. KEEP THIS USER MANUAL FOR FUTURE REFERENCE. For future reference, record the serial number of your colour monitor.
- Page 2 NOTE: The information in this manual is subject to change without notice. The manufacturer assumes no responsibility for any errors that may appear in this manual. TRADEMARK ACKNOWLEDGEMENT VGA is a registered trademark of International Business Machines Corporation. Apple and Macintosh are registered trademark of Apple Computer, Inc. VESA is a trademark of a nonprofit organization, Video Electronics Standard Association.
-
Page 3: Plug And Play
FWTURES ......................I CAUTIONS......................2 ‘ INSTALLATION ....................8= STANDARD SE~lNGS ..................10 Operation ...................... II POWER SAVING SYSTEM ................17 PLUG & PLAY ....................17 ..................... 18 SPECIFICATIONS The following features are provided by the Colour Monitor. Sharpest Focus and Highest Contrast Flat screen CRT with anti-glare, dynamic focus circuit, dark glass, and an INVAR shadow mask gives the sharpest focus and highest contrast to minimize eye fatigue. - Page 4 NEVER REMOVE THE REAR COVER! — The rear cover MUST be removed only by authorized service personnel. This colour monitor contains highvoltage components. THE RECEPTACLE SHOULD BE CLOSE TO THE MONITOR AND EASILY — ACCESSIBLE 9 iNSTALL THE UNIT IN AN SUITABLE ENVIRONMENT DO NOT expose this monitor to rain or moisture to prevent electric shock or fire hazard.
- Page 5 CAUTION for 200- 240V operation only This equipment relies on the protective devices in the building installation for short-circuit and over- current protection. Refer to the following table for the suitable number and location of the protective devices which should be provided in the building installation. Protective devices in single - phase equipment or sub - assemblies Location Protection...
- Page 6 FCC (Federal Communications Commission) STATEMENT WARNING for models CM811 ET, CM812ET and CM813ET WARNING : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 7 FCC (Federal Communications Commission) STATEMENT WARNING for model CM814ET WARNING : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
-
Page 8: Important For United Kingdom
FOR THE CUSTOMERS IN THE U.K. THIS PRODUCT IS SUPPLIED WITH A TWO PIN MAINS PLUG FOR USE IN MAINLAND EUROPE. FOR THE U.K. PLEASE REFER TO THE NOTES ON THIS PAGE. IMPORTANT FOR UNITED KINGDOM — WORDING FOR CLASS EQUIPMENT INSTRUCTION BOOKS AND LABELS... -
Page 10: Front View
L INSTALLATION ‘ , taking care to maintain safety. Install the monitor in the following w — Rear Cover Signal Input Connector AC inlet REAR VIEW FRONT VIEW 1.Installation Install the monitor on a horizontal base. 2. Power Cord Connection @ Make sure of using the power cord meeting the safety standard of the... - Page 11 Use a signal cable with the D-Sub Mini 15-pin Connector. l“, m-mnarti~n ““,,,, ””.,. Red Ground Green Groul Rl, ka (km Inr -,-” ””,, No connect~n Ground “. No connection Bi-directional Data [SDA] H. Sync. (or H/V) v Sy PJcW Datan;iock [SCL] the graphics board supplies more than one type of sync.
- Page 12 STANDARD SETTINGS Microprocessor-based preset functions can store 26 sets of geometry settings including the standard settings. The following industrial standard settings have been pre-programmed by the factory. Video Mode Name 3 VESA 1024X 768 -85 68.68 kHz “~ “~ 4 ADDle 1152x 870 -75 68.68 kHz Macintosh...
-
Page 13: Power On/Off
m 00 o~o Oooooo — Control Switches &@9@@:~:m .. —- ——— Q“@ Select Switch Adjust Switch Page 11 “DEGAUSSING’ Page 11-14 “ADJUSTMENT Page 11 “POWER ONIOF~ POWER ON/OFF Press the Power switch, to switch the power ON or OFF. When power is ON, the power LED lights. DEGAUSSING Press the switch ‘tDEGAUSS”, to degauss manually. - Page 14 ADJUSTMENT (Continue) — Adjust Switch Select — Item Switch Function makes Contrast brighter excluding background. Contrast makes Contrast darker excluding background, makes Brightness brighter including back-ground Brightness @) ~ I makes Brightness darker including background. moves the position to the right. H.
- Page 15 All II I.QTMFNT (Cnntinlw.) .-”-” . ,.. -.= . \--, .”,.--/ AdjustSwitch Select Function Item Switch changes the colour to the next mode. ;olorSelect No. fl,9300K + No.2:6500K NO.3:5000K No.4:USER (if available) changes the colour to the previous mode. No.4:USER (if available) No.3:5000K No.2:6500K No.
- Page 16 ADJUSTMENT (Continue) Adiust Switch Select Item Switch operates the horizontal more changing H. Moire @and@@ Reduction simultaneously. stops the horizontal moire changing circuit. > makes the operation of the horizontal “-i moire changing circuit stronger. makes the operation of the horizontal moire changing circuit weaker.
-
Page 17: Quick Store
STORE Your settinus will automatically be stored when the easv menu disatmears. Restoring Condition Item Storing Condition. H, Position One setting is allowed for each video mode. When the monitor detects the same video H.Size You can store maximum 26 sets of geometry V. -
Page 18: Signal Check
SIGNAL CHECK ........To refer to the input signal condition, press any switch 0 CONTRAST -<~}+ – (Select Switch or Adjust Switch). horizontal frequency and vertical frequency will be indicated. ~ BR IGHTNESS 5@ E4~}la — Precision frequency, S0 kllz/ 75Hz —... - Page 19 SAVING SYSTEM ‘ L POWER This monitor complies with VESA ENERGY STAR@ power saving requirements. The power saving system works only when used with VESA DPMS compliant PC’s and/or graphic controllers. “Note: When monitor is switched off by use of the Power Switch during the Power Saving ‘OFF mode, the LED will sometimes continue to flash for a few seconds.
- Page 20 21 inch picture tube, 0.22 mm horizontal dot pitch (0.21 mm horizontal mask pitch), Short persistence Invar shadow mask, Black matrix, phosphors, New Anti-Reflection coat. Video : 0.70 Vp-p, Analogue Input Signal : Separate HAl, lTL level Sync. ComDosite H/V. TTL level Sync.
- Page 21 Fax: +46 (0) 8 562 711 13 Tel: +39 02 38073415 Servizio Clienti Email: csgswe@hitachi-eu.com Fax: +39 02 48786381/2 Email: customerservice.italy@hitachi-eu.com HITACHI EUROPE S.A.S HITACHI EUROPE LTD (Norway) AB Lyon Office STRANDVEIEN 18 B.P. 45, 69671 BRON CEDEX 1366 Lysaker FRANCE...