Installation; Automatic Channel Scan; Manual Channel Scan; First Time Installation - Hitachi HDR255 Instruction Manual

• Audio: by pressing " "/" " keys change the audio
language.
• Subtitle: alter the subtitle language with " "/" " keys.
The chosen language will be seen in subtitles.
• Guide: by pressing " "/" " keys change the guide
language.
Current
• Audio: if audio language is supported change the
audio language by pressing " "/" " keys
• Subtitle: if subtitle is backed up alter the subtitle
language with " "/" " keys. The chosen language will
be seen in subtitles.

Installation

Automatic Channel Scan

Automatic channel scan is activated by selecting OK
when the line is highlighted. A pop-up menu appears
on the screen, select "YES" the automatic scan
begins. All the multiplexes are searched and a channel
table is created automatically. All channels found are
stored in a sorted form with respect to their channel
numbers. Selecting "NO" will cancel the operation.

Manual Channel Scan

In manual search the number of the multiplex is
entered manually and only that multiplex is searched
for the channels. In manual and auto search, any
existing channel in the database is not re-stored to
avoid redundant duplicates of that channel. To start
the scan enter the channel number manually and
press OK.

First Time Installation

Use this option to load default settings, which had
been set at the factory. To install factory settings,
highlight 'First Time Installation' menu and press OK
key, then you will be asked to confirm deleting all
channels and settings. Selecting YES and pressing
OK will delete the channel table. Selecting "NO" and
pressing OK will cancel the operation.

Message

When the box receives no signal (e.g. the antenna
(cable is disconnected), "NO
SIGNAL" message is seen on the
screen.
When there are no channels stored in the box;
he Channel List menu is not accessible. Channel
navigation is not allowed. Therefore, trying to enter
these menus or navigate the channels will display an
error message on the screen.
Specific Functions of Remote Control
When there is no menu active on the screen, each
of the keys have specific functions.
OK KEY: when OK key is pressed Channel list
appears on the screen.
RECORD KEY
The programs are recorded at once.
• Record time is attained from EPG automatically. If
the program has EPG information, you could set the
timer. If there is no EPG info, press the Record button
to set the timer in 30 minutes periods.
• In EPG by pressing the record key, programs are
recorded instantly.
LIB KEY : by pressing this key, you will get to the
Recordings Library, which shows you the details of
your saved recordings. By pressing it again, you will
exit the Recordings Library.
SUBTITLE : subtitle key shows/hides subtitles of
channel. When the subtitle key is pressed,subtitle
ON/OFF message is displayed.
INFO KEY
When INFO key pressed, and when changing
channels the information window is displayed on
the lower part of the screen. The small bar indicates
the program duration. On the channel info window
there are
• Current event name next event name, and their start
and end times.
• Program duration bar
• Program mode (TV or Radio)
• Channel number
• Name of the channel
PR+ / PR – (CHANNEL NAVIGATION )
There are two ways to navigate through the
channels:
• Pressing PR +/ PR - keys will take you to go to the
next or the previous channel in the list.
English - 18 -