OPERATING AND INSTALLATION INSTRUCTIONS FOR ELECTROLUX REFRIGERATORS INTRODUCTION CONTENTS We are pleased that you have chosen this refrigerator and OPERATING INSTRUCTIONS ..... 8 hope you will derive much satisfaction from using it, but first CONTROLS .
Only use one source of energy at a time not blocked by snow, leaves etc. The position numbers refer to fig. 3. ELECTROLUX ventilation grilles A 1620 (fig 2), can be fitted with winter covers, model WA 120, to protect the LP Gas operation cooling unit against cold air.
TRAVEL CATCH CLEANING THE REFRIGERATOR Make sure that the travel catch is engaged when the cara- Clean the inside of the refrigerator regularly to keep it fresh van is on the move, (fig 1). and hygienic. The travel catch at the top of the door can be set in two different positions.
Service and spare sparts are obtainable from your dealer or panel by sliding it downwards. Electrolux - consult the telephone directory Fit new panel in place and slide it up as far as possible. Fit the trim moulding back in place.
Fitting the grilles, model A 1620, which were specially The refrigerator must not be exposed to radiated heat from developed by Electrolux for this purpose (shown as D in fig. hot objects (e.g. below a cooker without proper heat shiel- 6).
The gas installation should only be carried out by an autho- 230 V Supplies. rized gas fitter. Check that the voltage stated on the data plate is the same The supply pipe should preferably be of copper. If any other as the mains voltage in use (230 V).