Faucet Electronics - Kenmore 625.384610 Owner's Manual

FAUCET ELECTRONICS
Inside the faucet base is a battery operated 6 month
timer. See Figure 14.
An amber LED indicator is also located in the front of the
faucet base. This LED will flash continuously after 6
months has passed. This indicates that it is time to
replace the battery and filter cartridges.
CHANGE BATTERY
To change (or install) the battery, complete the following
steps.
1. Loosen the screw on the right side of the faucet base
See Figure 14.
2. Press the battery housing upwards from the front
faucet base until it releases from the faucet base. See
Figure 14.
3. Replace (or install) the battery (Maxell CR 2032 or
equivalent). Place battery into the holder with the pos-
itive (+) side facing the back of the holder.
4. When the battery is first replaced it will flash six times
and turn off. This indicates the battery is fully
charged. After the six flashes, the timer enters the 6
month time cycle.
NOTE: If the LED repeatedly flashes just two times, it is
not a fully charged battery and will need to be replaced.
5. Re-install the timer housing and firmly tighten the
mounting screw. See Figure 14.
battery
housing
batter%
negative (-) ____L_
side facing / _1
the front___ screw
faucet _ L_ _'
base __
Figure 14
Questions? Call The I<enmore Water Line 1-800-426-9345 or visit I<enmoreWater.com
9