Care And Cleaning - GE Profile PCR06WATSS Owner's Manual And Installation Instructions

Beverage center and wine chiller
Table of Contents

Advertisement

Available languages

Available languages

Care and cleaning,
gecom
Cleaning the Outside
IMPORTANT:Unplug the beverage center
or wine chiller before cleaning.
Keep the outside clean. The cabinet can
be washed with mild soap and water. Rinse
thoroughlg with clean wateE Never use
abrasive scouring powders.
Use a glass cleaner or mild soap and water
and a soft cloth to clean the glass dooE Do
not use ang abrasive powders.
Wipe the controls with a damp cloth. Drg
thoroughlg. Do not use cleaning sprags,
large amounts of soap and water, abrasives
or sharp objects on the panel-theg
can
damage it. Some paper towels can also
scratch the control panel.
Do not wipe the beverage center or wine
chiller with a soiled dishcloth or towel.
These mabl leave a residue that can
erode the paint. Do not use scouring pads,
powdered cleaners, bleach or cleaners
containing bleach because these products
can scratch and weaken the point finish.
Stainless steel Regularlg clean and polish
the stainless steel areas (on some models)
with a commerciallg available stainless
steel cleaner such as Stainless Steel Magic ®
to preserve and protect the fine finish.
Stainless Steel Magic® is available through
GE Parts and Accessories, 800.626.2002, or
ge.com. Order part number WX10X15.
Do not use appliance wax or polish on the
stainless steel.
Cleaning the Inside
IMPORTANT: U nplug the beverage center or
wine chiller before cleaning.
The vinyl door gasket may be cleaned
with mild soap and water or a baking soda
solution. Rinsewell.
After cleaning the door gasket, applg a thin
lager of paraffin wax or petroleum jellg to the
door gasket at the hinge side.This helps keep
the gasket from sticking and bending out of
shape.
Use a slightlg damp cloth or sponge when
cleaning around switches, lights or controls.
Use warm water and baking soda solution-
about a tablespoon (15 ml) of baking soda
to a quart (1 liter) of wateE This both cleans
and neutralizes odors. Thoroughlg rinse and
wipe drg.
Other parts of the beverage center or wine
chiller unit-including
the full extension
drawers and glass shelves-can be cleaned
the same wag.
Avoid cleaning cold glass shelves with hot
water because the extreme temperature
difference may cause them to break. Handle
glass shelves carefully. Rough handling of
tempered glass can cause it to shatter.
Do not use detergents, scouring powders,
sprag cleaners or other harsh chemicals to
clean the interior.
Drain Hole
Periodicallg check the drain hole and
channel for ang debris. If the drain is blocked,
condensation will not drain properlg,
To check and clean the drain hole, remove
the bottom two glass shelvesor bottom two
full extension drawers. Sweep a damp cloth
along the channel in the back of the beverage
center. Use a finger to sweep awag ang debris
from the drain hole.
Light Bulb Replacement
Unplug the beverage center or wine chiller
before replacing the light bulb.
To remove the light shield, push in the tab on
the left side of the shield and lower it. Replace
with a !5 watt appliance bulb.
In the Event of a Power Failure
If the power fails, open the door as
infrequentlg as possible to maintain
the temperature.
Do not store or use gasoline
or other
flammable
vapors
and liquids in the vicinitg
of this or ang other
appliance.
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Profile pcr06batss

Table of Contents