Craftsman 113.206891 Owner's Manual page 20

:rnaintenance
5. Hold cutterhead pulley firmly with one hand and
loosen Iockscrews in each wedge using a 5/32 in.
setscrew wrench.
BLADE
WEDGE
LI FTE R LOCKSCR EW
SCREW
WEDGE
HOLD PULLEY
FIRMLY
5/32 IN. /
SETSCREW TURN COUNTER
WRENCH CLOC KWISE
\ , j TOLOOSEN
_,- ,, .I _ . _ .......
• i
FENCE NOT SHOWN
FOR PICTURE CLARITY
]111 iii , i i ii llul i
I I
SMALL SCREWDRIVER
6. While holding cutterhead pulley firmly with one hand,
gently pry up each wedge using a screwdriver..
remove wedges and blades,
7. Remove the six lifter screws. (Two under each blade.)
8. Clean cutterhead, wedges and screws thoroughly with
Craftsman Gum and Pitch Remover. also remove the
oil from new blades.
" SETSCREW ....
5/32 IN.
WRENCH
BLADE ------
LIFTER WEDGE LOCKSCREW._L_ "---'J
--.--..,_..,...,,. ,,, -,
t
CUTrER HEAD
SETSCREW
9. Replace the six lifter screws and screw them in all the
way, but do not tighten. Mark each slot 1, 2, and 3. This
witl help you in setting the blades.
• , ,_ : : , i: _, •,:, : • •
_ _/ii:i: :'_i _ / i:__i_i _!i_i}iiii_' _: : _:_ i_i__? _ :! _.....
MARK SLOTS
20 ¸