Applications; Detergent Adding And Use; Pump Lubricant; Starting And Stopping The Pressure Washer - Craftsman 138.75275 Operator's Manual

• If the screen is damaged, do not use the
machine until the screen has been replaced.
• If the screen is dirty, clean it before
connecting the garden hose to the machine.
• With the hose faucet turned completely off,
attach the end of the garden hose to the
water intake. Tighten by hand.
washers; household detergents, acids, alka-
lines, bleaches, solvents, flammable material, or
industrial grade solutions can damage the pump.
Many detergents may require mixing prior to
use. Prepare cleaning solution as instructed on
the solution bottle.
To add:
See the INSTRUCTION ILLUSTRATIONS
section of this Operator's Manual for the
Figures referenced in the instructions below.
_, WAR N I N G ! Do not allow familiarity with
the product to make you careless. Remember
that a careless fraction of a second is sufficient
to inflict serious injury.
,_, WAR N I N G ! Always wear eye protection
with side shields marked to comply with ANSI
Z87.1. Failure to do so could result in objects
being thrown into your eyes resulting in
possible serious injury.
,_, WAR N I N G ! Do not use any attachments
or accessories not recommended by the
manufacturer of this product. The use of
attachments or accessories not recommended
can result in serious personal injury.
,_ WA R NIN G! Never direct a water stream
toward people or pets, or any electrical device.
Failure to heed this warning could result in
serious injury
APPLICATIONS
You mav use this product for the purposes
listed below:
• Disconnect pressure washer from power
supply.
• Place pressure washer upright on a flat
surface.
• Remove cap from detergent tank.
• Pour detergent into tank.
To use:
The dial is used to control the suction between
detergent tanks and increase/decrease
detergent flow.
• Turn dial to choose the desired tank.(See
Figure 7-2.)
• Connect black soap nozzle to the wand
connector.(See Figure 7-3.)
• Squeeze the trigger and the detergent will
automatically be mixed with the water and
dispensed from the nozzle.
NOTE: Use a funnel, if needed, to prevent accidental
spiring of the detergent outside the tank. If any deter-
gent is spired during the filling process, make sure the
unit is cleaned and dried before proceeding.
• Reinstall cap.
PUMP LUBRICANT
The pressure washer pump has been filled with
sufficient lubricant at the factory and is main-
tenance free. You do not need to check or add
lubricant to the pump before initial use.
• Cleaning boats, cars, trucks, motorcycles,
outdoor furniture, grills, house siding,
driveways, patios and decks.
DETERGENT ADDING AND USE
(See Figure 7-1.)
,_ CAUTION
Use only approved pressure washer detergent
cleaners. Do not use bleach, chlorine, or any
detergents cleaners containing acids.
Use only detergents designed for pressure
STARTING AND STOPPING THE
PRESSURE WASHER (See Figure &)
_i, CAUTION
Do not run the pump without the water supply
connected and turned on.
• Connect the garden hose.
• Turn the garden hose on then squeeze the
trigger to relieve air pressure. Once a steady
stream of water appears,release the trigger.
• After ensuring the On/Off switch is in the OFF
( O ) position,connect the pressure washer to
10-English