Vocal Harmony; Setting Up The Vocal Harmony Control Parameters - Yamaha Tyros4 Reference Manual

Vocal Harmony

8
8
- Adding Harmony Vocals and Synth Vocoder to Your Singing -

Setting up the Vocal Harmony Control Parameters

The following parameters determine how the Vocal Harmony (Vocal Harmony and Synth Vocoder) is controlled. The
setup is common for all types.
1
Press the [VH TYPE SELECT] button to call up the Vocal Har-
mony Type Selection display.
2
Press the [8 ] (SETUP) button to call up the Setup display,
then set the value by using the [2 ]-[5 ] and [7 ] but-
tons.
For information on each parameter, see
NEXT PAGE
96
Tyros4 Reference Manual
Contents
Setting up the Vocal Harmony Control Parameters..................................... 96
Editing the Vocal Harmony Types ................................................................. 98
• Editing the Overview Tab Parameters ........................................................ 99
• Editing the Part Tab Parameters ............................................................... 101
• Editing the Detail Tab Parameters............................................................ 102
Editing the Synth Vocoder Types ................................................................. 103
• Editing the Overview Tab Parameters ...................................................... 104
• Editing the Detail Tab Parameters............................................................ 106
page 97.
NOTE
Check that the microphone is properly
connected (Owner's Manual, chapter
11) and the settings (Reference Manual,
page 118) are adjusted correctly before
setting the Vocal Harmony Control
parameters here.