Fujitsu F9600 Interface Manual page 18

LinkPlus Interface Guide: Fujitsu F9600 Telephone System
18
Using the Autodial feature
1. To use the Autodial feature, perform the following steps:
2. Press on the same handset that was programmed above.
START
3. Press the Autodial key sequence for the number to be dialed (
+ + , +
4, FCN 5 FCN 9
The pre-programmed number is then dialed.
4. Wait for your party to answer.
5. Press when the call is completed.
END
Effect of power loss
Note that the Autodial numbers are stored in the MCU/Gateway and
each number must be reprogrammed per step a through f each time
the system loses power or is shut off.
, or
FCN +*).
FCN
PN: 1725-36134-001_E.doc