Epson STYLUS 7890 User Manual page 173

Message
CANNOT OPEN INK COVER
CLEANING ERROR
AUTOMATIC HEAD
CLEANING FAILED
RETRY?
YES
NO
CLEANING ERROR
NOT ENOUGH INK OR
SPACE IN MAINT TANK.
CONTINUE CLEANING?
YES (RECOMMENDED)
NO
COMMAND ERROR
CHECK DRIVER SETTINGS
CUTTER UNIT NEARING
END OF SERVICE LIFE.
RECOMMEND REPLACING
THE CUTTER UNIT
FRONT COVER OPEN
CLOSE COVER
F/W INSTALL ERROR
UPDATE FAILED RESTART
THE PRINTER
INK CARTRIDGE
INK LOW REPLACE INK
CARTRIDGE
INK CARTRIDGE
NON-GENUINE CARTRIDGE!
QUALITY OF NON-GENUINE
INK MAY VARY.
INK CARTRIDGE
PLEASE USE GENUINE
EPSON INK CARTRIDGES
Explanation
Something is obstructing the
indicated ink cover
Head cleaning did not clear the
nozzles.
Not enough ink or not enough
maintenance tank capacity for
head cleaning.
You may be using the wrong
printer driver.
Damaged data was sent to the
printer or the data has an
incorrect command.
The paper cutter may be dull.
Front cover is open.
Firmware update failed.
The ink cartridge is expended.
A non-genuine ink cartridge is
installed.
A non-genuine ink cartridge is
installed.
173
Solving Problems
Response
Remove the obstruction and press the
button again.
Press to clear the error and run the
head cleaning utility again. If cleaning
doesn't start, cancel printing from the
computer. Then turn the printer off and back
on again.
Select Yes and replace the cartridge (see
page 153) or maintenance tank (see
page 163).
Press the Pause/reset button to
cancel the print job and reset the printer.
Make sure you installed the correct driver
for your printer.
Replace the paper cutter; see page 159.
Close the front cover.
Restart the printer, then update the
firmware again; see page 52.
Replace the ink cartridge; see page 153.
Select DECLINE and replace the ink
cartridge with a genuine Epson ink cartridge;
see page 153.
Replace the ink cartridge with a genuine
Epson ink cartridge; see page 153.
| 173