Wireless Network Installation; Connect The Ethernet Cable - Epson WorkForce 600 Series Network Installation Manual

Wireless Network Installation

To add the printer to your wireless network, you need to know the name (SSID)
of your wireless network. If it has security enabled, you also need to know the
WEP key or passphrase. Write down the SSID and WEP key or passphrase below:
■
Network name (SSID): _________________________________________
■
WEP key or passphrase: _________________________________________
Note:
If the WEP key is either 5 or 13 characters, it's ASCII. If the WEP key is either 10 or 26
characters, it's hexadecimal. The default WEP key is usually 1.
If your passphrase contains upper- or lowercase letters, be sure to note it correctly.
The printer supports the following wireless security modes: WEP 64, WEP 128, and
WPA-PSK.
If you don't know your wireless network name (SSID) or WEP key or passphrase,
contact the person who set up your wireless network before you begin.

Connect the Ethernet Cable

Note:
This is a temporary connection used to configure the printer. You will be prompted to
remove the cable when configuration is complete.
1. Connect an Ethernet network cable to the ( port on your printer.
LAN 10/100)
Wireless Network Installation
3