Advertisement
STEP 2: (SEE FIGURE 2 AND 1)
•
Slide the axle through the two axle brackets.
•
Assemble a spacer (R), a 3/4" washer (H), a wheel
ivalve stem facing out) and another 3/4" washer (H)
onto the axle. Assemble a cotter pin (M) through the
end of the ax{e. Repeat on other end
•
Tighten the four nuts which fasten the axle c_amps to
the frame tubes. Refer back to figure 1
1/8" x 1-1/2"
COTTER PIN (M
SPACERiR )
3/4" WASHER (H)
FIGURE
2
STEP 4: (SEE FIGURE 4)
Fasten the ends of the hitch arms together using two
5/16" x 1-1/4" hex bolts (E) and 5/16" nylock nuts (F).
Do not tighten yet.
•
Assemble the hitch brackets to the hitch arms using
two 5/16" x 2" hex bolts (A) and 5/16" nylock nuts
(F). Position each bolt behind a cross bolt in the hitch
arms. Do not tighten
yet.
•
Tighten all nuts assembled in steps 3 and 4 at this
time
5/16" x 2"
HEX BOLT (A)
5/16" NYLOCK
NUT i F)
5/15" x 1-1/4
HEX BOLT (B)
'
5t16" NYLOCK _
!
NUT (F)
FIGURE 4
STEP 3: (SEE FIGURE 3)
•
Assemble a hitch arm to the inside of a frame tube
underneath the tank Use two 5/16" x 2" hex bolts (A)
and 5/16" nylock nuts (F) Do not tighten
yet. Repeat
for other side
6" NYLOCK
NUT (F)
5/15" x 2"
HEX BOLT (A)
HITCH ARM
STEP 5: (SEE FIGURE 5)
•
Assemble the boom mount b_acket to the rear of the
frame tubes using two 5/16" x 2" hex bolts (A) and
5/16" nylock nuts (F)
5/16" NYLOCK NUT (F)
5/16" x 2"
HEX BOLT !A)
FIGURE 3
FIGURE 5
REAR VIEW
5
Advertisement
