Advertisement
The
wet/dry
vac
may
also
be
used
for
blowing
using
the seven
foot
hose
sup-
plied with the wet/dry
vac.
install
the blower
adapter
in the blowing
port of the wet/dry
vac.
The
blower
adapter
will
insert
into
the
inside
of the push
button
end of the vac
hose.
Assemble
the hose
to the blower
adapter
and connect
the blower
nozzle
to
the opposite
end of the hose.
The unit is ready for blowing
applications.
Blowing Port
Blower Nozzle
Blower Nozzle
Blower
Adapter
Maintenance
Blower
Intake
WARNING:
To reduce
the risk of
I
I
injury from
accidental
starting,
unplug
power
cord before
changing
or cleaning
filter.
After using the detachable
blower
of your
wet/dry
vac,
examine
the bottom
of the
blower
for dust and debris.
Check
to see if
the intake
to the blower
has debris
stuck
to the plastic
vents and foam
pad.
To clean
the foam
pad under
the intake
shield
of the detachable
blower:
1. Remove
the three
screws
holding
the
intake shield.
2. Lift the intake shield
off and set aside.
3. Lift the foam
pad away
from the
detached
blower,
the foam
pad holder
will also lift away
from the blower.
4. Remove
the foam
pad from the foam
pad holder
and set the foam
pad holder
to the side. Clean the foam pad in warm
soapy water
or brush
debris
away.
Allow foam pad to dry.
5. Examine
foam
pad for reuse.
If you
need to replace
it, check
the service
part section
of this manual.
'_
Foam
Pad
Holder
Foam
Pad
_
Intake
_
Shield
4"=
Screws
(3)
6. Replace
foam pad holder
on blower
with the tabs away
from the blower.
Reinstall
foam
pad under the tabs of
the holder.
7. Reinstall
intake shield
and 3 screws.
The unit is ready for use.
13
Advertisement
