Mounting Motor; Installing Motor Pulley; Tensioning Belt - Craftsman 113.213151 Owner's Manual

MOUNTING MOTOR f
1 Locate four (4) 8mm Dia x 20mm long hex head j/
bolts, eight (8) flat washers, and four (4) hex nuts
among loose parts. JY _'_
2. install hex head bolts through motor bracket on j,z _
f J
head. --, ,jJ.- /
3. Place motor in position so motor base slots line up . _:4
with motor bracket SlOtS. Install flat washers and
hex nuts as illustrated, iDo not tighten)
4. Motorshaftshould be as c_oseas possibletocenter
of round opening in belt guard.
8ram DIA. x 20turn LONG BOLT HEX NUT
AT WASHER
iNSTALLiNG MOTOR PULLEY
1. Find the motor pulley in loose parts _3ag.
2, Slide pulley onto motor shaft. Line up the flat sur-
face on the motor shaft with the set screw in pu Iley.
3. Make sure the pulley does not rest on the lower
guard.
4. Tighten the set screw using a 3ram Hex"L" wrench.
M(
:KET
MOTOR
BASE
HEX
NUT
FLAT
WASHER
HEAD
BOLT
MOTOR
PULLEY
SET SCREW
FLAT
SURFACE
iNSTALLiNG AND TENSIONING BELT
WARNING: To avoid injury due to accidental
starting always turn drill press off and remove
switch key before making belt adjustments.
t. Place a straight edge such as a piece of wood,
metal, or framing square across the top of pulleys.
2. Move the motor upward untilthe pulleys are in line.
Tighten the motor mount nuts using an adjustable
wrench,
NOTE: To avoid rattles or other noise, motor frame \
must not touch lower belt guard. \
\
3. Release Belt Tension Lock handles located on
each side of Drill Press head by turning them
counterclockwise.
STRAIGHT EDGE
LOWER
BELT
GUARD
BELT
TENSION
LOCK
HANDLE
MOTOR
MOUNT
NUTS
MOTOR
BELT
TENSION
HANDLE
4 _oosen Belt Tension handle by turning clockwise.
12