Playing Moviemate Audio Through An External Audio System - Epson MovieMate 30s User Manual

Playing MovieMate Audio Through an
External Audio System
You can connect MovieMate to an audio receiver, 5.1 Stereo Surround Sound System, or
digital audio recorder. To output sound from MovieMate, the external equipment needs to
have an optical audio input port.
Note: For additional convenience, Epson has developed an optional Wireless 5.1 Surround Sound
System adapter for the MovieMate 30s Series. To find out more about this accessory, go to
www.epson.com/homeentertainment.
You will also need an optical digital cable, which may be provided with your external
equipment, or may be purchased from an electronics store.
1. Remove the protective cap from the
2. Make sure the equipment is turned off, then connect the cable as shown:
Digital audio recorder
Audio receiver
3. Turn on your audio equipment and play your movie, music, or other presentation with
sound from MovieMate.
4. You can adjust the volume input level by pressing and holding the
approximately 2 seconds.
hold the button again to select
You may also need to change the
Audio Setup menu. Make sure you use the
systems. You can also use any of MovieMate's other audio controls, as described on
pages 42 through 43.
Note: After you disconnect your external audio equipment, make sure you replace the cap on the
Optical Audio Out port and close MovieMate's port compartment cover.
28
Using MovieMate With Other Equipment
Wireless 5.1 Surround
Sound System adapter
(audio transmitter
portion)
Optical digital cable
LEVEL 1
LEVEL 2
Digital Audio Output
Optical Audio-Out
appears on MovieMate's display window. Press and
and increase the volume.
Stream/PCM
port and keep it in a safe place.
button for
or settings in the
Downmix
setting for surround sound