All The Lights Are Flashing; The Printer Has Finished Charging The Ink Cartridge; After You Install Your Printing Software, You See The Windows 95 New Hardware Found Window - Epson 800 User Manual

Troubleshooting

All the lights are flashing.

Possible cause
You haven't removed all the
packing material from the
printer.
An internal error has
occurred.
The printer has finished charging the ink cartridge, but the
light is still flashing.
Possible cause
The ink cartridge clamp
isn't locked down.
Packing material remains in
the carriage.
The printer needs to
initialize.
The printer software installed with Windows 3.1 doesn't work
correctly after you upgrade to Windows 95.
Possible cause
Your printer software is not
set up correctly for
Windows 95.
After you install your printing software, you see the Windows 95 New
Hardware found window.
Possible cause
An operating system error
has occurred.
Solution
Remove the packing material, following the instructions on the
notice sheet in the box. If the printer still doesn't print, contact
EPSON as described in the Introduction.
Turn off your printer, wait a few seconds, and turn it on again. If
the lights still flash or stay on, contact EPSON as described in the
Introduction.
Solution
Press down on the clamp to lock it.
Remove all packing material, following the instructions on the
notice sheet.
If the printer is not moving or making noise, but the light is still
flashing for more than 5 minutes, turn the printer off. If the light is
still flashing when you turn it back on, contact EPSON as described
in the Introduction.
Solution
Reinstall the printer software after installing Windows 95.
Solution
Do not install a driver
Click
6-10
P
OK
, and then click .
power