Panasonic AG-VP310 Operating Instructions Manual page 53

Select the digital output to be output from the optical
digital audio output connector of DECK.
Press ACTION
to display DVD MAIN MENU.
2
Press A_F
to select
"AUDIO OUTPUT,"
and
press SET
to display screen.
IN A LJO[O OUTPUT
Press _I,V
I_)_o_/It_)igital :Bi ..........
to select an item,
dt_ ; Bit,,t ream
ore :OFF and
press SET
_ELEOT :-" repeatedly for
SET : SET
..... iON
output. (See below.)
• "LPCM (DVD)" selections
OFF: Linear PCM of less than 44.1 or 48 kHz/16 bit
is output. When playing DVDs recorded in
linear PCM of over 44.1 or 48 kHz/20 bit, no
digital audio is output. (Factory preset)
PCM: When playing DVDs recorded in linear PCM of
44.1 or 48 kHz/20 bit/24 bit or more, digital
audio converted to 44.1 kHz/16 bit or 48 kHz/
16 bit is output.
(Digital output of PCM audio is restricted to
48 kHz!16 bit or below for copyright
protection.)
• "Dolby Digital" selections
Bitstream: Dolby Digital bitstream (1 ch - 5.1 ch)
is output. (Factory preset)
PCM: When you have connected an amplifier that
doesn't have a built-in Dolby Digital decoder.
• "dts" selections
Bitstream: DTS bitstream is output. (Factory preset)
PCM: When you have connected an amplifier that
doesn't have a built-in DTS decoder.
• "DRC (Dynamic Range Compression)"
selections
OFF: Normal audio range is selected. (Factory preset)
ON: For dynamic sound even at low volume,
this is useful for late-night listening.
[Dolby Digital DVDs only].
_1_ Ready Checklist
[] DECK is in DVD mode, press DVD.
Recommended setting
Type of amplifier
to be connected LPCM Dolby DTS
(DVD) Digital
No amplifier is connected
AV amplifier (with digital
audio input connector)
withoutDolbyDigital/DTS PCM PCM _ PCM q
decoder
AVarnplifierincluding PCM Bitstream PCM
Dolby Digital decoder
AV amplifier including ,_
OolbyDigital/DTSdecoder PC M Bitstream Bitstream
• Make settings according to amplifier
connected to optical audio output as
shown in above table.
"1 When connecting an amplifier (with an
optical digital input connector) which
does not contain the Doiby Digita_ or
DTS decoder, be sure to select
"PCM'. If "Bitstream" )s selected,
starting DVD play may cause such a
high level of noise as to be harmful to
your ears and damage the speakers.
*2 When a dts decoder is connected,
please select "Bitstream" in "tits."
If "PCM" is selected, there will be
stereo sound.
When a Dolby Digital decoder is
connected, please select "Bitstream"
in "Dolby Digital."
If "PCM" is selected, there will be
stereo sound.
Press ACTION to redisplay DVD MAIN
MENU and go to step 2 to setup another
item.
Or, press ACTION twice to exit.
53