Loading The Laundry; Laundry Detergents And Additives; Dispensing The Correct Amount Of Detergent; Filling Laundry Detergent And/Or Additives - Bosch Nexxt 500 Plus series Operating & Installation Instructions Manual

Sorting laundry according
to care label specifications
XXTRA Hot
SANITARY t25" F i 52" C
170 ° F / 77° C
cold
60 ° F / 15" C
consult fabric care label for washing
instructions and temperature settings
Fabric Types
Machine Wash, Cottons _/
Machine Wash,
Permanent Press
Machine Wash, Delicates _/
Hand Wash _/
Temperatures
Cold _/
Warm _/
Hot "_
Do not wash clothes in washing
machine if the care label says "Do Not
Wash" or the DO NOT WASH symbol
£d is on the care label.
Loading the laundry
TO AVOID EXPLOSION HAZARD!
Items of clothing that have been
pretreated with solvent-based
cleaning agents, e.g. stain remover
and dry cleaning solvents, represent
an explosion hazard once loaded
into the washing machine.
Therefore, these items must first be
rinsed thoroughly by hand.
Loose debris in the washing
machine drum can damage the
laundry. Before loading the laundry,
check that there is no debris in the
drum.
CI Open the door.
CI Unfold the sorted items of clothing
and place them loosely into the
drum. Mix up large and small
items. Items of varying size will
distribute better during the spin
cycle.
D Do not exceed the maximum load.
Overloading will cause poor wash
results and increase wrinkling.
For best results it is recommended to
load the drum depending on the fabric
type.
Full Load
Cotton and Linens
1/2Load
Permanent Press, Synthetic Blends
and Knitwear
_3 Load
Wool, Delicates, Silk
D Close the door.
Do not trap any items of
clothing between the door and
rubber seal.
Door should be able to close
easily, not by force.
Laundry
Detergents and
Additives
Dispensing the correct
amount of detergent
TO AVOID RISK OF POISONING!
Keep detergents and additives out
of the reach of children.
Measure out the detergent (powder or
liquid) according to:
- The water hardness. This
information can be obtained from
your local water authority. Soft
water requires less detergent.
- The amount of laundry.
- The degree of soiling. Information
on soiling can be found on Page
40.
The specifications of the detergent
manufacturer. Measuring the
correct amount of detergent
relieves the strain on the
environment and ensures optimum
washing results.
Too little detergent:
The laundry is not cleaned properly and
will eventually become gray and stiff.
Grayish brown spots (fat globules) may
appear on the laundry. The heater may
calcify.
Too much detergent:
Not environmentally friendly, excessive
suds reduce wash agitation producing
poor washing and rinsing results or
may prevent proper spinning.
Filling laundry detergent
and/or additives
Detergent
CI Open the flap of the detergent
dispenser.
CI Add the detergent and/or additive.
14