Seiko Epson Corporation. The information contained herein is designed only for use with this Epson printer. Epson is not responsible for any use of this information as applied to other printers.
Safety Instructions Read all of these instructions before using your printer. Also be sure to follow all warnings and instructions marked on the printer. Warning, Cautions, and Notes Warnings must be followed carefully to avoid bodily injury. Cautions must be observed to avoid damage to your equipment.
3-inch core Power cord Note: ❏ The contents in the printer box vary by location. ❏ There are 4 ink cartridges for EPSON Stylus Pro 4400 and 8 ink cartridges for EPSON Stylus Pro 4800. Paper tray...
Setting Up the Printer Connecting the power cord 1. Check the label on the back of the printer to make sure the voltage required by the printer matches that of the wall outlet. Also, make sure that you have the correct power cord for your power source.
❏ The following illustration uses EPSON Stylus Pro 4800. Slot # 5 to 8 are not available on EPSON Stylus Pro 4400. ❏ The right ink compartment of EPSON Stylus Pro 4400 cannot be opened.
5. Hold the ink cartridge with the arrow mark facing up and pointing to the rear of the printer, and then insert it in the slot. 6. Repeat steps 4 to 5 to install the other ink cartridges. 7. After inserting all ink cartridges in their corresponding slot, lower the ink levers.
Page 8
Attaching roll paper to the printer To attach roll paper to the printer, follow the steps below. 1. Open the roll paper cover. 2. Make sure that the movable flange is fixed into the end of the roll paper properly.
Roll Auto Cut On on the LCD. Caution: Do not leave the paper in the printer for a long period of time; its quality will deteriorate. We recommend that you remove the paper from the printer after printing.
Page 10
17 lb or 64 g/m² plain paper. Do not load the paper above the arrow mark on the inside surface of the left edge guide. For information on the loadable capacity of Epson special media, see the following table. Epson special Size Loadable...
A4, Letter size, or 8 × 10 in. paper in the portrait position, regardless of the thickness. 1. Make sure the printer is on and in the READY state. 2. Press the Paper Source...
Note: Make sure the roll paper support is not raised. Caution: Do not leave the paper in the printer for a long period of time; its quality will deteriorate. We recommend that you remove the paper from the printer after printing.
Page 13
Printer Software” on page 14. Using the optional interface card The following optional Ethernet interface card lets you use your printer on a network. The Ethernet interface card automatically detects the protocols on your network, so you can print from Windows XP, Me, 98, and 2000, or Mac OS X and 9.x on an AppleTalk network.
With background printing on, you can use your Macintosh while it is preparing a document for printing. In order to use the EPSON Monitor IV utility to manage print jobs, background printing must be turned on. 4. Close the Chooser.
10.3.x). 5. Click Add. 6. Select the interface that connects the printer and computer. 7. Select Stylus Pro 4400 or Stylus Pro 4800. 8. Click Add. 9. Make sure the Printer List contains the printer you just added. 10. Close the Printer List dialog box.