Belt Tension Adustment; Positioning Of Toolrest - Craftsman 113.228360 Owner's Manual

BELT TENSION ADJUSTMENT
1. Place belt tension adjustment lever in middle of
long slot, BELT TENSION
ADJUSTMENT LEVER"
SLOT
2. Notice which lever support notch is immediately
below belt tension adjustment lever. Place lever in
this notch by pushing down and sideways on the
lever,
The lever is spring loaded so if belt slips during
operation, place lever in next lower notch.
POSITIONING OF THE TOOLREST
The tool rest should be positioned I/'8 inch above cen-
terline of workpiece and 1/8 inch away from the section
on the workpiece to be cut.
WARNING: Failure to position the tool rest as
described can result in a turning tool being
thrown from your hand, causing severe injury.
TOOL
1t8"
SQUARE WORKPIECE
TOOLREST POSITIONED 1/8"
ABOVE CENTERLINE OF
WORKPIECE
TOOLREST POSITIONED 118"
AWAY FROM WORK
.o--1/8"
ROUND WORKP]ECE
p.
e- 0.)
o F:
p, u'j
---_,¢c
<:D ,._
.o_
O r"
o
25