Assembly Instructions; Tool Rests; Spark Arrestors - Craftsman 152.211240 Owner's Manual

A 12mm x 10mm open endwrench is provided f or
mounting t heToolRest A ssemblies andtheSpark
Arrestor Assemblies,.
1, DONOTassemble t heBench Grinder u nti! y ouare
surethetoolISNOTplugged in.
2, DONOTassemble t heBench Grinder u ntil y ouare
surethepower s witch is inthe"OFF" p osition,
3., DONOTassemble t heBench Grinder u ntil y ouare
surethegrinding w heels arefirmly tightened t othe
Bench Grinder,,
TOOL RESTS (Figs. D and E)
The Bench Grinder is provided with two Tool Rests
assemblies,,
1,, Remove Tool Rest Assemblies from the plastic bags
and check to see that you have the following:
Tool Rest (2)
Tool Rest Support (2)
5/16-18 x 3/4" Hex head screw (2)
5/16" Lock Washer (2)
5/16" Flat Washer (4)
5/16-18 x 1/2" Hex head screw (4)
2,. Assemble the Tool Rest Supports (A) to the inside
surface of the Wheel Covers (B) with the flat
washers (C) and 1/2" long hex head screws (D) as
shown° See Figure D,.
3., Assemble the Tool Rests (E) to the Supports (F)
with the lock washers (G) and 3/4" long Hex head
screw (H) as shown. See Figure Eo
4,, Adjust each Tool Rest until its inside edge (1) is
1/16" from the grinding wheel Firmly tighten the
hex head screws holding the supports and tool
rests, See Figures D and E
Fig. D
Fig. E
SPARK ARRESTORS (Fig F)
1 Remove both Spark Arrestor Assemblies from the
plastic bags and check to see that you have the
following:
Left Side Spark Arrestor
Right Side Spark Arrestor
1/4" Flat Washer (2)
t/4-20 x I/4" Hex head screw (2)
2,, Assemble the Spark Arrestors (A) to the inside
surface of the Wheel Covers (B) with the flat
washers (C) and hex head screws (D) as shown.
See Figure F
3, Adjust each Spark Arrestor until the lower edge (E)
is 1/16" from the grinding wheel. Firmly tighten the
hex head screws_ See Figure E
Fig. F
B