Advertisement
WARNING: Always r emove b attery pack
from your
sew when you are assemblingparts, making
adjustments,assemblingor removingblades,
cleaning, or when not in use. Removing battery pack
will prevent accidental startingthat could cause
serious personalinjury.
Note: Your sew is assembled with the battery pack
attached,
TO REMOVE BATTERY
PACK
See Figure 4.
•
Locate latches on side of battery pack and depress to
release battery pack from your sew. See Ffgure 4.
•
Remove battery pack from your sew.
DEPRE88 LATCH r-._ TO
RELEASE BATI'ERY PACK
TO
REMOVE
TO
LATCHES
INSTALL
BATr F._RY PACK
Fig, 4
TO ASSEMBLE
OR REMOVE BLADE
TO ASSEMBLE BLADE:
See Figure 5.
WARNING: A5-1/2 in. blade is the maximum blade
capacity of your sew. Never use a blade that is too
thick to allow outer blade washer to engage with the
fiats on the spindle. Larger blades will come in
contact with the blade guard, while thicker blades will
prevent blade screwfrom securingblade on spindle,
Either of these situationscould resultin a serious
accident.
•
Remove battery pack from saw,
A
WARNING:
Failure to remove battery pack from
sew could result in accidental startingcausing
passible serious personal injury.
•
Locate latcheson side of batterypack and depressto
release battery pack from yoursew. See F/gum 4.
SRNDLE
LOCK BUTTON
LOWERBLADE
GUARDHANDLE
BLADE
INNER
BLADE WASHER
OUTER
BLADE WASHER
BLADESCREW Fig. 5
•
Remove blade wrench (5 mm hex key) from storage
area. See Figure 1.
•
Depress spindlelock button and remove blade screw
and outer blade washer, See Figure 5.
Note: Turnblade screwdcckwise to remove,
•
Wipe a drop of oil onto inner bladewasher and outer
blade washer where they contact blade.
WARNING: If inner blade washer has been re-
moved, replace it before placingblade on spindle.
Failureto do so could cause an accidentsince blade
will not tighten pmpedy,
•
Fit sew blade insidelower blade guard and onto
spindle,
Note: The sew teeth paint upward at the frontof sew
as shownin figure 5.
• Replace outer bladewasher.
•
Depress spindlelock button,than replace blade screw,
"nghtanblade screw securely,
Note: Turn blade screw countemlockwise to tighten.
•
Ratum blade wrench to storage area.
REMEMBER: Never use a blade that is too thick to
allow the outer blade washer to engage with the fiats
on the spindle.
12
Advertisement
