Assembly; Assembly Of Column And Table Hardware - Craftsman 113.213170 Owner's Manual

assembly
WARNING: FOR YOUR OWN SAFETY, NEVER CON*
NECT PLUG TO POWER SOURCE OUTLET UNTIL
ALL ASSEMBLY STEPS ARE COMPLETED.
TOOLS NEEDED *
I.._.l'"I" I"" ' ' .... " ' " "___
15/16 _ BOX END j ..... , ....... ,._.,..(_
WRENCH COMBINATION I"
MEDIUM 8-INCH ADJUSTABLE
SCREWDRIVER WRENCH
i i i i
FRAMING SQUARE MUST BE TRUE.
Check its accuracy as illustrated below.
DRAW LIGHT
LINE ON BOARD
ALONG THIS EDGE _,,
STRAIGHT EDGE OF
BOARD 3/4" THICK--
THIS EDGE MUST BE
PERFECTLY STRAIGHT
SHOULD BE NO GAP OR OVERLAP WHEN
SQUARE IS FLIPPED OVER IN DOTTED POSITION
ASSEMBLY OF COLUMN AND TABLE
HARDWARE
1. Position base on floor. Remove protective covering
and discard.
2, Remove protective sleeve from column tube and
discard. Place column assembty on base, and align
holes in column support with holes in base.
3. Locate (4) four 10ram Dia. x 40ram long bolts (see
illustration) in loose parts bag.
4. Install a bolt in each hole through column support
and base and tighten with adiustable wrench.
COLUMN
SUPPORT
10ram OIA. x 40mm
LONG BOLT
BASE
.
6.
7.
.
Locate table crank and supportlock in loose parts
box.
Install support lock from left side into table support
and tighten by hand,
Install table crank assembly and tighten set screw
with a 3mm HEX "V' wrench.
SUPPORT
LOCK
TABLE
SUPPORT
Position column collar over rack and tighten set
screw in collar, using 3mm HEX "L" wrench,
supplied in loose parts bag. Collar should not be
angled on the column. Only tighten set screw
enough to keep collar in place; rack should still
slide freely in collar.
CAUTION: To avoid column or collar damage,
do not overtighten set screw,
COLUMN
COLLAR
COLUMN
i
TABLE
SUPPORT
TABLE
CRANK
HANDLE
10