CHANGING
THE COLLET
The 1/8" collet is used with 1/8" diameter
bits, the 1/4" collet is used with 1/4" diameter
bits and the 5/32" collet is used with 5/32"
diameter
bits. To change collets, first
remove
the bit. Continue
to loosen and
unscrew
the collet nut until you can remove
it
from the tool.
Remove the collet and replace
it with the other (Fig. 5). (Each collet is
double-ended,
and either end is acceptable
to use.)
By hand, re-tighten
the collet nut
around the collet in a clockwise
direction.
You are now ready to insert a new bit as
instructed
in Installing
Bits (Fig. 3 or 4).
COLLET
OUTPUT
SHAFT
REMOVING
AND INSTALLING
THE HARD
AUXILIARY
CONTROL
HANDLE
Turn the tool OFF and unplug it. Firmly
grasp the tool.
Lift open handle release
button cover, depress
release button and
remove
handle (Fig. 6).
Gently engage the two (2) front latches on
handle into the tool and push handle until it
snaps securely
into place.
\
\
HANDLE
RELEASE
BUTTON
COVER
HANDLE
BUTTON
REMOVING AND INSTALLING
THE SOFT HANDLE)
_
Always use auxiliary
handle for maximum
control over torque reaction or kick-back.
1 Depress and hold top clip release (Fig, 7).
2 Pull strap away from tool (Fig, 7).
While top clip hook release is depressed, pull
I I1[_:!
IP
handle strap straight away from tool (Fig. 7).
3 Squeeze
from each side and hold both
bottom clip releases
(Fig. 8).
4 Lift the back of the clip up and away from
tool (Fig. 8).
While depressing
both bottom clip release
tabs, lift the back of the clip away from the
tool (Fig.8).
CLIP
-10-