Troubleshooting - Craftsman 113.228000 Owner's Manual

TROUBLE SHOOTING CHART
TROUBLE PROBABLE CAUSE
ii.,
1. Defective On-Off switch,
Defective switch cord.
Defective switch box receptacle.
2. Motor protector open,
(only if your motor is
equipped with an
overload protector).
3, Burned out motor I
Motor will not run.
REMEDY
1. Replace defective parts before using Lathe
again,
2, Reset protector when motor has cooled.
3. Consult Sears Service. Any attempt to repair this
motor may create a HAZARD unless repair is
done by a qualified service technician. Repair
service is available at your nearest Sears Store.
.... t. Adjust bert tension, see Assembly Section.
: Lathe slows down 1. V-belt too loose
when turning
: Tailstock rocks • 1. Brass adjusting screw is too I Adjust screw. See Section, "Getting To Know
e"
back and forth loose. Your Lath .
excessively. ,
I I ee
Headstock oose _ 1. Setscrew not tight; :1. Tighten setscrew. S Section, "Getting To
on bed ....... _ . ; .... :KrioW Your Lathe". ..
Wood burnsat I i. CuP center too tight 0rln0t; I 1. Back off tailstock ram and lubricate
tai stock end I lubricated I ; ;cup center. See Basic Lathe Operation
- Sect on, SpndeTurn g
i !