On/Off Switch - Craftsman 113.238180 Owner's Manual

2..F_n_ t wo points anda spurand cupcenter a mong t he
loose parts. T o insert p ointintocenters, place center
between, jaws
of a vise. DO not tighten vice. Insert point
into center and wltfr a hammer and nail gently tap
around the base of the point until secure.
\
\
Insert spur center into head stock spindle and cup
center into tailstock ram. NOTE: Do not drive or
hammer centers into ,pindle or ram as removal may be
difficulL Use a soft hammer or block of wood and give
them a gentle tap.
To remove spur cen_er from spindle, ho_d the spindle
pulley with one hand, and, using a wrench or pair of
ptiers, turn the hex nut counterclockwise until center
isejected.
& To remove cup center insert a 114" wood dowel or brass
rod through the hole in the tailstock ram. Hold the
center with one hand and rap the dowel or rod with a
hammer.
\
\
CUP
.TAILSTOCK
RAM
FOOT
WARNING: DON'TCONNECT POWER CORD TO
ELECTRICAL OUTLET IN YOUR SHOP UNTIL
YOU ARE READY TO CHECK MOTOR ROTA-
TION.
ON-OFF SWITCH
The On-Off Switch has a locking feature. THIS FEATURE
IS tNTENDED TO PREVENT UNAUTHORIZED AND
POSSIBLE HAZARDOUS USE BY CHILDREN AND
OTH E RS.
1. Insert key into switch. ,_,.
NOTE:
Key is made of yellow plastic.
KEY
[y_LLOVz P_ AST _C
KEY
10