GE JBP90 Owner's Manual page 16

Usingthe clock and timer.
Make sure flTeclock is set to the
correct time of da_
To Set the Clock
The clock must be set to tile correct time
of day fl)r tile autonmfic oxen timino
fimcfions to work properly: The time of
din, cannot be changed, durino_ a timed
baking or seltXcleaning c) cle,
[] Touch tile CLOCKpad.
[] Touch tile nmnber pads.
[] Touch
tile START pad until tile
time of day shm_s in tile display:
The timer is a minute timer onltz
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Set the Timer
[]
[]
Touch tile
KITCHENTIMER
ON/OFF pad.
Touch tile number pads until tile
_lI//O[lnt OJV
tixne
VO/I W_lIlt sh()_,_LS
in tile display: For example, to set
2 houI_ and 45 nlinutes, touch 2, 4
and 5 in that ordex: If you make a
mistake touch the KITCHEN TIMER
ON/OFF
pad and begin again.
[]
[]
Touch
tile STARTpad.
_._/en tile timer reaches :00, tile
control will beep 3 times fi)llowed
bv one beep every 6 seconds tmtil
tile KITCHEN TIMER ON/OFF pad
is touched.
The6 second tonecanbe cance/ed b y fo//owlhg
thestepsin theSpecial f eatures of youroven
control s ectionunderTones a t theEndof a
timedCycle.
To Reset the Timer
If tile display is still showing tile time
remaining, you may change it by
touching tile KITCHEN TIMER ON/OFF pad,
then touch tile nmnber pads tmtil tile
time you want appea_ in tile displa);
If tile remaining time is not in tile display
(clock, delay start or cooking time are in
tile display), recall tile remaining time by
touching tile KITCHEN TIMER ON/OFF pad
and then touching tile nmnber pads to
enter tile new tiille vo[i _31ilt.
ToCancel the Timer
Touch tile KITCHEN TIMERON/OFF
pad twice.
/6