Brother MFC-J4710DW Quick Setup Manual page 24

Wired Network
For wired network interface users
18
Before you install
Make sure your machine is connected to the power
and your Macintosh is ON. You must be logged on
with Administrator rights.
NOTE
• For Mac OS X v10.5.0 to 10.5.7 users, upgrade
to Mac OS X v10.5.8 - 10.7.x.
• If you have previously set up your machine for
a wireless network and then want to set it up on
a wired network, you should check that the
machine's Network I/F is set to
Wired LAN. The wireless network interface
will become inactive with this setting.
On your machine, press
Press All Settings.
Press Network.
Swipe up or down, or press a or b to display
Network I/F.
Press Network I/F.
Press Wired LAN.
Press .
24
(Mac OS X v10.5.8, 10.6.x, 10.7.x)
.
19
Connect the network
cable
a
Lift the scanner cover until it locks securely into
the open position.
b
Connect the network cable to the Ethernet port
marked with a
Ethernet port inside the machine on the left, as
shown in the callout below. Remove the orange
protective cap before connecting the cable.
1
Macintosh
symbol a. You will find the