Epson PowerLite 1825 Quick Setup

Before using the projector, make sure you read the safety
instructions in the User´s Guide on your projector CD.
1
Turn On Your Equipment
1
C onnect the power cord to the back of the projector and plug the other
end into an electrical outlet.
2
O pen the A/V Mute slide (lens cover). Make sure the slide is opened
completely.
3
R emove the battery cover on the remote control. Locate the two AAA
batteries that came with the projector and insert them. Then replace the
battery cover.
4
T o turn the projector on, press the Power button on the projector or
the remote control. The projector beeps once, and the projector's
Power light flashes green and then stays on.
Power light
Power button
To shut down the projector:
1. P ress the Power button twice.
2. W hen the orange light stops flashing and the projector beeps,
you can unplug the projector.
2

Adjust the Image

1
T o raise the image, press the foot release button for the front adjustable
foot and lift the front. Release the button to lock the foot in position.
*411303300*
*411303300*
PowerLite 1825
®
Quick Setup
2
Turn the focus ring to sharpen the image.
Turn the zoom ring to reduce or enlarge the image.
Focus
3
I f your image looks like ,
button on the projector and follow the on-screen instructions.
3
Choose a
Presentation Method
How do you want to get images to the projector?
• T o connect to a notebook, see "If connecting
to a notebook" below.
• T o project over a wireless network, see
"If projecting wirelessly" on the back of this sheet.
Y ou must have installed the projector's EasyMP
your projector and computer before you can project wirelessly. See your
User's Guide for instructions.
• T o give a presentation stored on a CompactFlash
flash drive, digital camera, or other USB storage device, see
Chapter 5 in your User's Guide.
• T o connect to your notebook using the included USB cable,
see your User's Guide.
If connecting to a notebook...
1
T urn on the projector and adjust the image as described in
sections 1 and 2 on this sheet.
2
L ocate the computer cable that came with the projector.
Connect one end to the projector's blue Computer1 port.
Connect the other end to your notebook's video-out port or
monitor port.
3
P ress the Source Search button on the projector or the
Search button on the remote control until your computer
image is displayed.
NOTE: If your notebook has a DVI connector, you need to use an
optional DVI-to-VGA adapter with the included computer cable
(see your computer's documentation).
Zoom
, or , press the Quick Setup
,
Computer cable
software and configured
®
memory card,
®
Turn over