Table of Contents
Advertisement
Preparation
Installing the Lithium Batteries
Installing the Memory Battery
The supplied CR 1216 type lithium battery is
used to store the memory of the date and
time settings.
1
Make sure that the Power switch is
set to OFF.
2
Open the LCD monitor to a 90° angle
to the camcorder body.
3
Slide the battery release in the
direction of the arrow, then take the
battery pack out.
Battery release
4
Pull out the lithium battery cover in
the direction of the arrow.
5
Insert the smaller lithium battery into
the compartment with the H side of
the battery facing out.
6
Close the lithium battery cover firmly
12
until it clicks into place.
Lithium
battery cover
CR 1216 type
lithium battery
Removing the Memory Battery
Perform steps 1 to 4 above,
then lift out the battery by
using a pointed object such as
the tip of a ballpoint pen.
Installing the Battery to
Remote Control (VL-Z501D only)
The CR 2025 type lithium battery
supplied with VL-Z501D is used to power
the remote control unit.
1
Hold the remote control facing down,
and pull out the battery holder while
pressing the tab toward the centre.
Tab
2
Insert the larger lithium battery into the
battery holder with the H side of the
battery facing the m side of the holder.
H side, CR 2025 type
lithium battery
3
Insert the battery holder back into
position.
Notes on the Use of the Lithium battery
CAUTION: Danger of explosion if battery is
incorrectly replaced. For camcorder, replace
only with same or equivalent type CR1216, for
remote control unit, replace only with same or
equivalent type CR2025, both recommended
by the equipment manufacturer.
X KEEP THIS BATTERY AWAY
FROM CHILDREN. IF SWALLOWED,
CONSULT A PHYSICIAN IMMEDIATELY
FOR EMERGENCY TREATMENT.
Z BATTERY MAY EXPLODE IF
MISUSED OR INSTALLED WITH POLAR-
ITY REVERSED. DO NOT RECHARGE,
DISASSEMBLE OR DISPOSE OF IN FIRE.
"m" side
Advertisement
Table of Contents
