Configuring The Connection - Epson PowerLite 745c Manual

Depending on whether your projector is set up to
connect in Ad Hoc mode or Access Point mode (also called
infrastructure mode), you see this screen:
3. If you've already configured the projector for your wireless
network, go to "Projecting Wirelessly" on page 15.
Otherwise, continue with the next section.

Configuring the Connection

You must configure both the projector and your computer's
network settings to project wirelessly.
You can configure the projector for either of the following
modes:
Ad Hoc mode: Lets you connect just one computer at a time;
you need a computer with a wireless (802.11g or 802.11b)
network card or adapter, or a Macintosh with an AirPort
AirPort Extreme card.
Access Point mode: Lets multiple computers access the
projector, or trade off control of the projector; you need a
wireless (802.11g or 802.11b) access point or an AirPort (or
AirPort Extreme) base station, and one or more computers
with wireless network cards or adapters.
1. Switch the projector to EasyMP mode and insert the Epson
802.11G/B card.
2. When you see the EasyMP screen, press the
on the remote control to select
3. Use the pointer button to highlight
, the press
Wireless LAN
4. Select either
Easy connect mode
.
point mode
button
Enter
.
Config
under
Basic
.
Enter
(for Ad Hoc) or
Access
You see one of these screens:
® 5. Make sure the projector has a unique name so you can
or
identify it when connecting to it from your computer.
Use the
highlight the Projector Name text box, then press
The text box turns yellow to indicate you're in input mode.
Press the
in alphabetical order, or down to select letters in reverse
order. Then press the
move to the next character position. When done entering a
new setting, press
To enter numbers, press and hold the
remote control while pressing number buttons on the
numeric keypad. (The button lights up to indicate that the
numeric keypad is active.) Press the
exit numeric keypad mode. When done entering the
setting, press
8/04
Epson PowerLite 745c Projector
pointer button on the remote control to
pointer button up to select individual letters
pointer button to the right to
.
Enter
Num
Num
.
Enter
Epson PowerLite 745c Projector
Ad Hoc
mode
Access
Point
mode
.
Enter
button on the
button again to
11
-