Advanced Menu Settings; Set The Colors As Desired In Accordance With The Image Contents; Adjusting Color Balance; Setting The Video Type - Sharp PG-M10SE Operation Manual

Advanced Menu Settings

Set the colors as desired in accordance
with the image contents.
Subtle color settings are possible, as desired. Setting is
possible for each input.
1
Select the image to be input (page 20).
2
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
keys to select "COLOR".
3
Use the cursor
"GAMMA".
4
Use the cursor
"GAMMA".
The following can be selected.
G Normal G Natural G Real G Custom
Normal is standard settings; Natural stresses
coloring; Real stresses brightness. Custom is used
to adjust freely as desired.
5
Use the cursor
"CUSTOM", press the ENTER button to
display the sub-menu and then set the
gamma value. There are 33 index values.

Adjusting Color Balance

Color balance (white balance) can be set for each input.
1
Select the image to be input (page 20).
2
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
keys to select "COLOR".
3
Use the cursor
"COLOR TEMP".
4
Use the cursor
"COLOR TEMP".
Four different types of color balance can be set
beforehand: Low, Middle, Normal and High.
When the ENTER button is pressed, the sub-
menu will be displayed to enable fine
adjustment.
30
/
/ keys to select
/ keys to set the
/ keys to select
/
/ keys to select
/ keys to select the

Setting the Video Type

1
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
keys to select "COLOR".
2
Use the cursor
TYPE".
3
Use the cursor
TYPE".
The following can be selected.
G DVD G VCR
DVD is used for DVD players and Video is used for
normal video players.

Selecting the Color System

The following color systems can be used with this unit.
G NTSC G NTSC 4.43
G PAL G PAL-M G PAL-N
G SECAM
• Only "NTSC" and "PAL" can be used for component video.
• Selection is automatic when "AUTO" is used.
• "AUTO" cannot be set for PAL-M and PAL-N input signals. Select
"PAL-M" or "PAL-N" in "COLOR SYSTEM" menu for PAL-M and
PAL-N input signals.
1
Select an input for the color system to be
selected (page 20).
2
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
keys to select "COLOR".
3
Use the cursor
"COLOR SYSTEM" and then press the
ENTER button.
4
Use the cursor
desired color system.
To close the menu
Press the R-CLICK/EXIT button.
/
/ keys to select "VIDEO
/ keys to set the "VIDEO
G PAL60
/
/ keys to select
/ keys to select the