Electrolux Electric Range Use & Care Manual page 23

Problem Solution
Oven light does not work. ° Be sure the light bulb is secure in the socket. If the light bulb needs replaced
see "Changing and replacing the interior oven light."
Self-cleaning cycle does not work. • Oven control not set properly. Follow instructions under Self-cleaning.
° Self-cleaning cycle was interrupted. Follow steps under "Stopping or
Interrupting a Self-cleaning cycle" under Self-cleaning.
Soil not completely removed after self-
cleaning cycle.
• Failure to clean bottom, front top of oven, frame of oven or door area
outside oven seal. These areas are not in the self-cleaning area, but get
hot enough to burn on residue. Clean these areas before the self-cleaning
cycle is started. Burned-on residue can be cleaned with a stiff nylon brush
and water or a nylon scrubber. Be careful not to damage the oven gasket.
Oven smokes excessively during broiling. ° Incorrect setting. Follow "Setting broil" in Setting Oven Controls.
* Make sure oven door is open to the broil stop position.
* Meat too close to the broil element. Reposition the broil rack to provide
proper clearance between the meat & the element. Preheat the broil
element for searing.
* Meat not properly prepared. Remove excess fat from meat. Cut remaining
fatty edges to prevent curling, but do not cut into lean.
* Broiler pan and insert wrong side up and grease not draining. Always place
grid on the broiler pan with ribs up & slots down to allow grease to drip
into pan (some models).
* Grease has built up on oven surfaces. Regular cleaning is necessary when
broiling frequently. Old grease or food spatters cause excessive smoking.
Flames inside oven or smoking from * Excessive spillovers in oven. For example this will happen for pie
oven vent. spillovers or large amounts of grease left on the oven bottom. Wipe up
excessive spillovers before starting oven. If flames or excessive smoke
are present see "Setting broil" in the Setting Oven Controls section.
F code error (for example F10, Fll, clear the display & stop beeping. Try the bake or broil feature again. If the
F13, F14, F15, F30, F31 or F90). F code error repeats, remove power from appliance, wait 5 minutes and
then repower appliance and set clock for the time of day. Try the bake or
broil feature again. If the fault recurs, record fault and call for service.
Drip bowls are pitting or rusting (coil * Foods with acids, such as tomatoes, if allowed to stand in/on bowls will
cooktop models only), cause corrosiion. Remove and wash drip bowls as soon as possible after
a spill over.
* Normal environment. Houses located along sea coasts are exposed to salt air.
Protect bowls as much as possible from direct exposure to salt air.
Drip bowls are turning color or distorted * Bottom surface of cookware extends beyond surface element and touches
(coil cooktop models only), cooktop surface. This can cause high enough temperatures to discolor the
drip bowls. DO NOT use cookware of this type. Pan sizes should be matched
to the size of the element. Replacement drip bowls may be purchased from
your appliance dealer.