Connecting An Analogue Satellite Receiver And Vcr; Nokia Smart Switch; Connecting A Hifi System - Nokia Mediamaster 9802 S Owner's Manual

INSTALLATION OF THE MEDIAMASTER
Connecting a satellite receiver and a VCR
• Connect a SCART cable between the main SCART socket on
the TV and the TV SCART socket on the Mediamaster.
• Connect a SCART cable between the VCR and the AUX SCART
socket on the Mediamaster.
• Connect an RF cable from the RF output on the VCR to the TV
aerial input on the TV.
• Connect an RF cable from the RF output on the satellite re-
ceiver to the RF input socket on the VCR.
• Connect the TV aerial to the RF input socket on the satellite
receiver.
In order to switch the signal from the dish between the satel-
lite and digital receivers, you need a Nokia smart switch (at A
B in the diagram) or a Universal Twin LNB.

Nokia smart switch

• Connect a coaxial cable between output A on the smart switch
(accessory) to the LNB socket on the satellite receiver.
• Connect a coaxial cable between output B on the smart switch
to the ANTENNA socket on the Mediamaster.
The satellite receiver must be switched OFF (in standby
mode) when you want to watch digital satellite channels
from the Mediamaster.

Connecting a HiFi system

• Connect an RCA/Cinch stereo cable from the AUDIO L R sock-
ets on the Mediamaster to the LINE, AUX, SPARE or EXTRA
input sockets on your HiFi system.
• If available you can connect an RCA/Cinch single cable from
the DIGITAL AUDIO socket on the Mediamaster to your HiFi
or Dolby Pro Logic system.
Note: To avoid interference you must use a screened audio
cable.
Connecting to the built in phone modem
The built in phone modem makes it possible for you to use inter-
active services. Refer to page 38.
• Connect the attached telephone cable between the socket
marked TELEPHONE on the rear of the Mediamaster and the
ordinary telephone socket in the wall.
GB 10
With Nokia smart
switch
RF
SCART
Satellite receiver
Nokia smart switch
VCR
Media-
master